Abstract:In order to optimize their system design and manufacturing processes, it is crucial to undertake a thorough electrical and thermal characterization of micro thermoelectric generators (μTEGs). To address this need, a highly advanced and fully integrated in-situ measurement system has been developed. The main objectives of this system are to (1) enable the measurement of ZT and thereby of all thermoelectric properties of thermolegs made from powder-based thermoelectric materials and (2) at the same time accurately measure the contact resistance between the thermoelectric material and the electrical contacts. The μTEG fabrication concept used in this study is based on copper-cladded printed circuit board (PCB) material as a substrate, using the Cu layers for easy contact formation. In a first step, an innovative measurement concept, based on a distinctive vertical rendition of the well-established transfer length method (TLM), has been realized, allowing for the in-situ measurement of contact resistance between the thermoelectric (TE) material and the copper conductors on the PCB substrate. This enables a comprehensive assessment of the impact exerted by the applied force and temperature during e.g. a hot-pressing step for compacting the powder-based thermolegs during the manufacturing process. In a second step, a comprehensive measurement platform, referred to as the ZT-Card, has been devised to facilitate the evaluation of all relevant thermoelectric material properties – Seebeck voltage, electrical conductivity and thermal conductivity (all measured in vertical cross-plane orientation) – inherent to a highly miniaturized thermoleg. Additionally, the ZT-Card also allows for the assessment of contact resistance between the copper contacts and the thermoelectric material. Successful testing of this measurement system inspires confidence in the capabilities of the platform and will aid in future μTEG development.

Non-linear impedance spectroscopy applied to thermoelectric measurements: beyond the ZT estimation

Self-contained calibration samples and measurements of the thermoelectric figure of merit: A method to improve accuracy

Automated Instrumentation for the Determination of the High-Temperature Thermoelectric Figure-of-Merit

Measurement of non-equilibrium characteristics of thermoelectric materials

An in-depth study of nonlinear parametric characterization for thermoelectric generator modules

Innovating In-Situ Characterization: A Comprehensive Measurement System for Measuring the ZT and the Contact Resistance of Vertical Thermolegs Exploiting the Vertical Transfer Length Method

Ac Thermoelectric Response in the Nanostructure and Corresponding Nonlinear Kinetic Coefficients

Physical Intuition to Improve Electronic Properties of Thermoelectrics

Simultaneous Electrical and Thermoelectric Parameter Retrieval Via Two Terminal Current–Voltage Measurements on Individual ZnO Nanowires

High-throughput imaging measurements of thermoelectric figure of merit

Sommerfeld-Bethe analysis of ZT in inhomogeneous thermoelectrics

Anomalous thermal effect in observed via photothermal measurements

Toward thermoelectric characterization of (nano)materials by in situ transmission electron microscopy

Bipolar conduction asymmetries lead to ultra-high thermoelectric power factor

Control of thermoelectric properties of phase-coherent molecular wires

Transport property analysis method for thermoelectric materials: material quality factor and the effective mass model

Electronic transport computation in thermoelectric materials: From ab initio scattering rates to nanostructures

Terahertz-Induced Nonlinear Response in ZnTe

Thermoelectric efficiency of nanoscale devices in the linear regime

Building the Principle of Thermoelectric ZT Enhancement

Revealing the Intrinsic Electronic Structure of 3D Half‐Heusler Thermoelectric Materials by Angle‐Resolved Photoemission Spectroscopy