Abstract:We theoretically investigate the thermoelectric properties of semiconducting (gapped) materials by varying the degrees of polynomials in their energy dispersion relations, in which either the valence or conduction energy dispersion depends on the wave vector raised to the power of two, four, and six. The thermoelectric transport coefficients such as the Seebeck coefficient, electrical conductivity, and thermal conductivity are calculated within the linearized Boltzmann transport theory combined with the relaxation time approximation. We consider various effects such as band gaps, dimensionalities, and dispersion powers to understand the conditions that can give the optimal thermoelectric efficiency or figure of merit ($ZT$). Our calculations show that the so-called pudding-mold band structure produces larger electrical and thermal conductivities than the parabolic band, but no significant difference is found in the Seebeck coefficients of the pudding-mold and parabolic bands. Furthermore, we find that a high $ZT$ can be obtained by tuning the band gap of the material to an optimum value simultaneously with breaking the band symmetry. The largest $ZT$ is found in a combination of two-contrasting polynomial powers in the dispersion relations of valence and conduction bands. This band asymmetry also shifts the charge neutrality away from the undoped level and allows optimal $ZT$ to be located at a smaller chemical potential. With some reasonable values of thermal conductivity parameters, the maximum $ZT$ for the bulk systems can be larger than 1, while for one-dimensional systems it can even reach almost 4. We expect this work to trigger high-throughput calculations for screening of potential thermoelectric materials combining various polynomial powers in the energy dispersion relations of semiconductors.

Sommerfeld-Bethe analysis of ZT in inhomogeneous thermoelectrics

Anisotropic Lattice Thermal Conductivity In Topological Semimetal Zrgex (X = S, Se, Te): A First-Principles Study

High ZT 2D Thermoelectrics by Design: Strong Interlayer Vibration and Complete Band‐Extrema Alignment

Machine learning for predicting ultralow thermal conductivity and high ZT in complex thermoelectric materials

High zT and Its Origin in Sb‐doped GeTe Single Crystals

Giant Seebeck Coefficient Decrease in Polycrystalline Materials with Highly Anisotropic Band Structures: Implications in Seeking High-Quality Thermoelectric Materials

Synergy of grain size and texture effect for high-performance Mg3Sb2-based thermoelectric materials

Strong Phonon-Phonon Interactions Securing Extraordinary Thermoelectric Ge 1- x Sb x Te with Zn-Alloying-Induced Band Alignment.

Engineering of charge carriers via a two-dimensional heterostructure to enhance the thermoelectric figure of merit.

Ultralow Lattice Thermal Conductivity and Superhigh Thermoelectric Figure‐of‐Merit in (Mg, Bi) Co‐Doped GeTe

Distinctive Thermoelectric Properties of Supersaturated Si-Ge-P Compounds: Achieving Figure of Merit ZT > 3.6

Band Modulation and Strain Fluctuation for Realizing High Average zT in GeTe

Compositional Fluctuations Locked by Athermal Transformation Yielding High Thermoelectric Performance in GeTe

Discordant Distortion in Cubic GeMnTe2 and High Thermoelectric Properties of GeMnTe2- x%SbTe

Bipolar conduction asymmetries lead to ultra-high thermoelectric power factor

Anomalous Enhancement of Thermoelectric Performance in GeTe with Specific Interaxial Angle and Atomic Displacement Synergy

Anion-site-modulated Thermoelectric Properties in Ge 2 Sb 2 Te 5 -Based Compounds

Properties and Microstructures of a High-Performance Thermoelectric Intermetallic Compound — β-Zn<sub>4</sub>Sb<sub>3</sub>

Intrinsically Low Lattice Thermal Conductivity and Anisotropic Thermoelectric Performance in In‐doped GeSb2Te4 Single Crystals

Thermoelectric properties of semiconducting materials with parabolic and pudding-mold band structures

First-principles Study of Lattice Thermal Conductivity in ZrTe5 and HfTe5