Abstract:Gibbs adsorption and Zener pinning induced by MgB2 decomposition are proven to inhibit grain growth for enhancing mechanical properties and cutting processibility of Bi2Te3‐based alloys with improved thermoelectric performance. An average figure of merit of 1.1 within 300–473 K can be obtained in (Bi0.4Sb1.6Te3)0.97(MgB2)0.03, and an energy conversion efficiency of 4.2% at a temperature difference of 215 K can be achieved in an eight‐pair device. Bi2Te3‐based alloys have great market demand in miniaturized thermoelectric (TE) devices for solid‐state refrigeration and power generation. However, their poor mechanical properties increase the fabrication cost and decrease the service durability. Here, this work reports on strengthened mechanical robustness in Bi2Te3‐based alloys due to thermodynamic Gibbs adsorption and kinetic Zener pinning at grain boundaries enabled by MgB2 decomposition. These effects result in much‐refined grain size and twofold enhancement of the compressive strength and Vickers hardness in (Bi0.5Sb1.5Te3)0.97(MgB2)0.03 compared with that of traditional powder‐metallurgy‐derived Bi0.5Sb1.5Te3. High mechanical properties enable excellent cutting machinability in the MgB2‐added samples, showing no missing corners or cracks. Moreover, adding MgB2 facilitates the simultaneous optimization of electron and phonon transport for enhancing the TE figure of merit (ZT). By further optimizing the Bi/Sb ratio, the sample (Bi0.4Sb1.6Te3)0.97(MgB2)0.03 shows a maximum ZT of ≈1.3 at 350 K and an average ZT of 1.1 within 300–473 K. As a consequence, robust TE devices with an energy conversion efficiency of 4.2% at a temperature difference of 215 K are fabricated. This work paves a new way for enhancing the machinability and durability of TE materials, which is especially promising for miniature devices.

Synergy of grain size and texture effect for high-performance Mg3Sb2-based thermoelectric materials

High performance of Mg3Bi1.5Sb0.5 based materials for power generation: Revealing the counter-intuitive effect of tuning Bi content on the thermoelectric properties

Enhancement of thermoelectric performance in Mg 3 (Sb,Bi) 2 through engineered lattice strain and controlled carrier scattering

High thermoelectric performance and anisotropy studies of n-type Mg3Bi2-based single crystal

Effect of Composition Adjustment on the Thermoelectric Properties of Mg3Bi2-Based Thermoelectric Materials

Graphene-assisted synergistic electronic DOS modulation and phonon scattering to improve the thermoelectric performance of Mg3Sb2-based materials

Boosting room-temperature thermoelectric performance of Mg 3 Sb 1.5 Bi 0.5 material through breaking the contradiction between carrier concentration and carrier mobility

Excellent thermoelectric performance of boron-doped n-type Mg3Sb2-based materials via the manipulation of grain boundary scattering and control of Mg content

Synergistic modulation of mobility and thermal conductivity in (Bi,Sb)2Te3 towards high thermoelectric performance

Na/Bi-co-doping and Heterogeneous Interfaces Leading to Enhanced Thermoelectric Performance of P-Type Mg3Sb2-based Zintls

Inhibiting Mg Diffusion and Evaporation by Forming Mg‐Rich Reservoir at Grain Boundaries Improves the Thermal Stability of N‐Type Mg3Sb2 Thermoelectrics

Synergistic Texturing and Bi/Sb‐Te Antisite Doping Secure High Thermoelectric Performance in Bi 0.5 Sb 1.5 Te 3 ‐Based Thin Films

Electronic Orbital Alignment and Hierarchical Phonon Scattering Enabling High Thermoelectric Performance p-Type Mg 3 Sb 2 Zintl Compounds

Improved figure of merit (z) at low temperatures for superior thermoelectric cooling in Mg3(Bi,Sb)2

Gibbs Adsorption and Zener Pinning Enable Mechanically Robust High‐Performance Bi2Te3‐Based Thermoelectric Devices

Plastically Mg3(Sb,Bi)2-based thermoelectric compounds with enhanced texture via cold-deformation

Bi-Deficiency Leading to High-Performance in Mg3 (Sb,Bi)2 -Based Thermoelectric Materials

Interface and Surface Engineering Realized High Efficiency of 13% and Improved Thermal Stability in Mg3Sb1.5Bi0.5‐Based Thermoelectric Generation Devices

Characterization of a penta-and an octasaccharide from urine of a patient with juvenile GM1-gangliosidosis.

Roles of concentration-dependent Cu doping behaviors on the thermoelectric properties of n-type Mg3Sb1.5Bi0.5

Realizing Cd and Ag codoping in p-type Mg3Sb2 toward high thermoelectric performance