Abstract:In nuclear medicine, the use of a pixelated semiconductor detector with cadmium telluride (CdTe) or cadmium zinc telluride (CdZnTe) is of growing interest for new devices. Especially, the spatial resolution can be improved by using a pixelated parallel-hole collimator with equal holes and pixel sizes based on the above-mentioned detector. High-absorption and high-stopping-power pixelated parallel-hole collimator materials are often chosen because of their good spatial resolution. Capturing more gamma rays, however, may result in decreased sensitivity with the same collimator geometric designs. Therefore, a trade-off between spatial resolution and sensitivity is very important in nuclear medicine imaging. The purpose of this study was to compare spatial resolutions using a pixelated semiconductor single photon emission computed tomography (SPECT) system with lead, tungsten, gold, and depleted uranium pixelated parallel-hole collimators at equal sensitivity. We performed a simulation study of the PID 350 (Ajat Oy Ltd., Finland) CdTe pixelated semiconductor detector (pixel size: 0.35 × 0.35 mm2) by using a Geant4 Application for Tomographic Emission (GATE) simulation. Spatial resolutions were measured with different collimator materials at equivalent sensitivities. Additionally, hot-rod phantom images were acquired for each source-to-collimator distance by using a GATE simulation. At equivalent sensitivities, measured averages of the full width at half maximum (FWHM) using lead, tungsten, and gold were 4.32, 2.93, and 2.23% higher than that of depleted uranium, respectively. Furthermore, for the full width at tenth maximum (FWTM), measured averages when using lead, tungsten, and gold were 6.29, 4.10, and 2.65% higher than that of depleted uranium, respectively. Although, the spatial resolution showed little differences among the different pixelated parallel-hole collimator materials, lower absorption and stopping power materials such as lead and tungsten had relatively better characteristics at specific sensitivities.

Evaluation of the Central Copper Contact Pin Effect in High-Energy Region in Gamma-ray Spectrometry

HPGe Detector Efficiencies for Extended Sources Using the Monte Carlo Method

Gamma ray registration efficiency simulation of a HPGe detector with PHITS

Analysis of the Influence of Spot Diameter of Point Sources on HPGE Detector Γ-Ray Efficiencies Simulation for Volume Source

A Simulation Study on the Flash X-Ray Spectra Spatial Distribution

Calculation of Self-Absorption and Coincidence Summing Correction Factors for the Extended Sources Using GEANT4

Monte Carlo Simulation of the Full Energy Peak Efficiency of an HPGe Detector.

Summing Coincidence Correction for Γ-Ray Measurements Using the HPGe Detector with a Low Background Shielding System

Monte Carlo Simulation of Ultra-high Resolution γ Detector

Calibration of HPGe Detector Efficiencies with Self-Absorption Correction of Gas Sphere Sources

The effect of high-resolution parallel-hole collimator materials with a pixelated semiconductor SPECT system at equivalent sensitivities: Monte Carlo simulation studies

Dead layer thickness and efficiency function of point source for HPGe detector

Efficiency and energy resolution of gamma spectrometry system with HPGe detector depending on variable source-to-detector distances

Detector efficiency calibration using 88Rb point source

Comparison of Geant4 with EGSnrc for Simulation of Gamma-Radiation Detectors Based on Semi-Insulating Materials

Feasibility Study Of Direct Beta Particle Detection Using Gas Electron Multiplier

Detection Efficiency Calculations Using Geant4 for a Broad-Energy Germanium Gamma Spectrometer

Calibration of HPGe Detector Efficiency

Computational model for detector timing effects in Compton-camera based prompt-gamma imaging for proton radiotherapy

Monte Carlo Simulations of the GE Discovery Alcyone CZT SPECT Systems

Development of a Monte Carlo simulation platform for the systematic evaluation of photon-counting detector-based micro-CT