Abstract:A differential, membrane-based nanocalorimeter for general specific heat studies of very small samples, ranging from 0.5 mg to sub-{\mu}g in mass, is described. The calorimeter operates over the temperature range from above room temperature down to 0.5 K. It consists of a pair of cells, each of which is a stack of heaters and thermometer in the center of a silicon nitride membrane, in total giving a background heat capacity less than 100 nJ/K at 300 K, decreasing to 10 pJ/K at 1K. The device has several distinctive features: i) The resistive thermometer, made of a Ge_{1-x}Au_{x} alloy, displays a high dimensionless sensitivity |dlnR/dlnT | \geq 1 over the entire temperature range. ii) The sample is placed in direct contact with the thermometer, which is allowed to self-heat. The thermometer can thus be operated at high dc current to increase the resolution. iii) Data are acquired with a set of eight synchronized lock-in amplifiers measuring dc, 1st and 2nd harmonic signals of heaters and thermometer. This gives high resolution and allows continuous output adjustments without additional noise. iv) Absolute accuracy is achieved via a variable-frequency-fixed-phase technique in which the measurement frequency is automatically adjusted during the measurements to account for the temperature variation of the sample heat capacity and the device thermal conductance. The performance of the calorimeter is illustrated by studying the heat capacity of a small Au sample and the specific heat of a 2.6 {\mu}g piece of superconducting Pb in various magnetic fields.

Comparison Among Coaxial Microcalorimeter Models

Improvements on INRIM Coaxial Microcalorimeter and Outcome of a Model Comparison

Thermoelectric Sensors as Microcalorimeter Load

Alternative Procedures in Realizing of the High Frequency Power Standards with Microcalorimeter and Thermoelectric Power Sensors

Comparison between Thermoelectric and Bolometric Microwave Power Standards

Improvement of primary power standard through international comparison feedback

Equivalent method of GaAs PHEMT MMIC for thermal simulation

The True-Twin microcalorimeter: a proof-of-concept experiment

RF/MW power standard realization without unitary efficiency assumption at dc/LF

National Coaxial Primary Standard for Broadband Power

Two Models for Bolometer and Microcalorimeter Detectors with Complex Thermal Architectures

Measurement and Analysis for Performance of Micro-thermoelectric Generator

Power Sensor Characterization From 110 to 170 GHz Using a Waveguide Calorimeter

Thermal Equivalence Error of Microwave Power Measurement

Thermal fluctuation noise in Mo/Au superconducting transition-edge sensor microcalorimeters

Data Fitting and Analysis of Performance for Micro-thermoelectric Generator

Feasibility Analysis on Radiant Transient Heat Flux Meter Calibration System

Analyzing the Automatic Power Level Control Effect of a Signal Generator in RF Power Sensor Calibration by a Direct Comparison Transfer Method and a Millimeter Wave Application

Membrane-based nanocalorimeter for high-resolution measurements of low-temperature specific heat

Verification of calibration methods for determining photon-counting detection efficiency using superconducting nano-wire single photon detectors

Modulated-bath AC calorimetry using modified commercial Peltier-elements