Abstract:To establish traceable radio frequency (RF) medium-power calibration and measurement capability, the National Institute of Metrology (NIM), China, designed the flow calorimeter-type RF medium-power standard. Operation frequency and power range of the standard are 10 MHz–8 GHz and 1–100 W, respectively. Subsequently, the calorimeter is operated under the RF condition to calibrate an RF medium-power transfer standard (TS) within the operation frequency and power range. A commercial RF medium-power sensor, as the device under test (DUT), is further calibrated by the TS under identical frequency and power conditions. Hence, the input RF medium power is traced to ac medium power with several correction factors. Though plenty of research on flow calorimeters has been published in the past decades, quantitative evaluation of correction factors in these measurements is still in shortage. In this article, the principle and process of DUT calibration using a flow calorimeter are described. Correction factors due to calorimetric fluctuation, power sensor efficiency of the calorimeter, and dissipated power in cables are analyzed with experiments. Measurement results reflect good stability and repeatability with standard deviation of the mean (SDOM) less than 0.5% of DUT calibration factor, with a mean value of calibration factor of approximately 0.99. Extending on previously published work, in this article, we complete correction factor analysis and the calibration principle with measurement results.

Alternative Procedures in Realizing of the High Frequency Power Standards with Microcalorimeter and Thermoelectric Power Sensors

Thermoelectric Sensors as Microcalorimeter Load

Improvement of primary power standard through international comparison feedback

Comparison Among Coaxial Microcalorimeter Models

The True-Twin microcalorimeter: a proof-of-concept experiment

RF/MW power standard realization without unitary efficiency assumption at dc/LF

Improvements on INRIM Coaxial Microcalorimeter and Outcome of a Model Comparison

Comparison between Thermoelectric and Bolometric Microwave Power Standards

National Coaxial Primary Standard for Broadband Power

Power Sensor Characterization From 110 to 170 GHz Using a Waveguide Calorimeter

Power Loss Measurement System for Soft Magnetic Materials in Megahertz Frequencies

Modulated-bath AC calorimetry using modified commercial Peltier-elements

Generalized Electrical Substitution Methods and Detectors for Absolute Optical Power Measurements

Cryogenic sensor enabling broad-band and traceable power measurements

A High Precision and Multifunctional Electro-Optical Conversion Efficiency Measurement System for Metamaterial-Based Thermal Emitters

Direct Implementation of a Frequency-Programmable Josephson Voltage Standard to Provide an SI Traceable Optical Power Scale

A Calibration Method for Power Metering System with Electronic Instrument Transformers

Calibration Principle and Correction Factor for Flow Calorimeter in RF Medium-Power Measurement

Design of passive wireless temperature measurement system for high voltage power equipment

Automated Instrumentation for the Determination of the High-Temperature Thermoelectric Figure-of-Merit

Simultaneous Measurement of Thermal Conductivity and Volumetric Heat Capacity of Thermal Interface Materials Using Thermoreflectance