Abstract:Presently Si-based field-effect transistors (FET) are approaching their physical limit and challenging Moore's law for their short-channel effect, and further scaling their gate length down to the sub-10 nm region is becoming extremely difficult. Two-dimensional (2D) layered semiconductors with atom-scale uniform thicknesses and absence of dangling bonds on the interface are considered as potential channel materials to support further miniaturization and integrated electronics. Wu F, et al. (2022 Nature 603 259) have successfully fabricated a FET with gate lengths below 1 nm using atomically thin molybdenum disulfide with exceptional device performance. This breakthrough has greatly encouraged further theoretical predictions regarding the performance of 2D devices. Additionally, 2D SnS exhibits high carrier mobility, anisotropic electronic properties, and stabilized in ambient condition conducive to advanced applications in 2D semiconductor technology. Herein, we explore the quantum transport properties of sub-5 nm monolayer (ML) SnS FET using first-principles quantum transport simulation. Considering the anisotropic electronic SnS, the double-gated-two-probe device model is constructed along the armchair and zigzag directions of ML SnS. After test five kinds of doping concentrations, a doping concentration of 5×10 13 cm -2 is the best one for SnS FET. We also used the underlap (UL) with range of 0, 2, and 4 nm to improve the device performance. On-state current ( I on ) is an important parameter for evaluating the transition speed of a logic device. A higher I on of a device can help to increase the switching speed of high-performance (HP) servers. The main conclusions are as follows. 1) I on of the n-type 2 nm (UL=4 armchair), 3 nm (UL=2), 4 nm (UL=3), 5 nm (UL=0) and the p-type 1 nm (UL=2 zigzag), 2 nm (UL=2 zigzag), 3 nm (UL=2,4 zigzag), 4 nm (UL=2,4 zigzag), and 5 nm (UL=0, armchair/zigzag) gate-length devices can meet the standards for HP applications for the next decade in the International Technology Roadmap for semiconductors (ITRS, 2013 version). 2) I on of the n-type device along the armchair direction (31-2369μA/μm) are larger than that in the zigzag direction (4.04-1943μA/μm), while p-type along the zigzag direction (545-4119μA/μm) are larger than that in the armchair direction (0.7-924μA/μm). Therefore, the p-type ML GeSe MOSFETs have a predominantly anisotropic current. 3) I on of the p-type 3 nm gate-length (UL=0) device along the zigzag direction has the highest valued 4119 μA/μm is 2.93 times larger than that in the same gate-length UL=2 (1407μA/μm). Hence, an overlong UL will weaken the performance of the device because the gate of the device cannot well control the UL region. Thus, a suitable length of UL for FET is very important. 4) Remarkably, I on of the p-type devices (zigzag), even at a 1 nm gate-length, can fulfill the requirements of HP applications for the next decade in the ITRS, with a value as high as 1934 μA/μm. To our knowledge, this is the best-performing device material reported at 1 nm gate length. 5) Subthreshold swing (SS) evaluates the control ability of the gate in the subthreshold region. The better the gate control, the smaller SS the device has. The limit of SS for traditional FETs is 60 mV/dec (at room temperature). Values of SS for ML SnS FET alone zigzag direction are less than those along the armchair direction because the leakage current is influenced by the effective mass.

High Mobility, High Carrier Density SnSe2 Field‐Effect Transistors with Ultralow Subthreshold Swing and Gate‐Controlled Photoconductance Switching

High Mobility 2D Palladium Diselenide Field-Effect Transistors with Tunable Ambipolar Characteristics.

High mobility top gated field-effect transistors and integrated circuits based on chemical vapor deposition-derived monolayer MoS 2

Field-effect transistors of high-mobility few-layer SnSe$_{2}$

Visible Phototransistors Based on Vertical Nanolayered Heterostructures of SnS/SnS2 P-N and SnSe2/SnS2 N-N Nanoflakes

Achieving Ultrahigh Electron Mobility in PdSe2 Field‐Effect Transistors via Semimetal Antimony as Contacts

Low Residual Carrier Concentration and High Mobility in 2D Semiconducting Bi2O2Se

SnSe field-effect transistors with improved electrical properties

High Photoresponsivity and Short Photoresponse Times in Few-Layered WSe2 Transistors.

Tunable Snse2/Wse2 Heterostructure Tunneling Field Effect Transistor

Toward High-mobility and Low-power 2D MoS2 Field-effect Transistors

Strain-Free Layered Semiconductors for 2D Transistors with On-State Current Density Exceeding 1.3 mA μm –1

High-performance Sub-5nm Monolayer Tin Sulfide (SnS) Field-effect Transistors: a First principles Study

Coplanar High Mobility and Interplanar Van Der Waals Heterojunction in Layered Two-Dimensional Bi2O2Se Nanosheets

High-Mobility Inse Transistors: the Role of Surface Oxides

High Mobilities in Layered InSe Transistors with Indium-Encapsulation-Induced Surface Charge Doping.

High Mobility Transistors and Flexible Optical Synapses Enabled by Wafer-Scale Chemical Transformation of Pt-Based 2D Layers

High-Performance Sub-10 Nm Two-Dimensional SbSeBr Transistors Through Transport Orientation.

Bulk photovoltaic effect and high mobility in the polar 2D semiconductor SnP2Se6

PdSe2/MoSe2: A promising van der waals heterostructure for field effect transistor application

Self-Modulation Doping Effect in the High-Mobility Layered Semiconductor Bi2O2Se