Abstract:Copper sulfides (Cu2–xS) have become potential thermoelectric (TE) materials because of their high element abundance, low toxicity, and high performance. A series of Cu1.8–2xBi2xS1–3xSe3x (0 ≤ x ≤ 0.03) bulks were fabricated using mechanical alloying and spark plasma sintering. The main Cu1.8S phase was obtained in all compositions of 0 ≤ x ≤ 0.03, and marginal Cu1.96S and Cu2S phases were detected at 0.02 ≤ x ≤ 0.03, which is attributed to the volatilization of sulfur and selenium. Benefiting from the introduced extra electronics by Bi3+ doping, the carrier concentration was optimized in 2.31×1021 cm–3. Multiscale defects introduced by Bi–Se co-doping, including secondary phases, micropores, and point defects (BiCu••, SeS×, and VS••), strongly scattered the phonons, leading to a drastically decreased thermal conductivity from 2.71 W m–1 K–1 for Cu1.8S at 773 K to 0.80 Wm–1 K–1 for Cu1.74Bi0.06S0.91Se0.09. A maximum ZT of 0.78 was achieved for Cu1.74Bi0.06S0.91Se0.09 at 773 K, which is 144% higher than that of Cu1.8S (0.32). The current stress test confirms that Bi doping could improve the stability of Cu1.8S by suppressing the Cu ion migration. Our work demonstrates that Bi–Se co-doping is an effective way to enhance the TE properties for Cu1.8S.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.2c00414.SPB model calculation of our work; method for the current stress test; calculation formulas for ZTeng and ηmax; temperature dependence of thermal properties of the Cu1.8–2xBi2xS1–3xSe3x (x = 0, 0.01, 0.02, 0.25, 0.03) samples; and repeatability test of electrical properties for the Cu1.74Bi0.06S0.91Se0.09 sample (PDF)This article has not yet been cited by other publications.

Enhanced thermoelectric performance of CoSbS via Se doping at dual Sb and S sites

Modification of the thermoelectric performance in Se alloyed CoSb1-xSexS

Enhanced Thermoelectric Performance of CoSbS0.85Se0.15 by Point Defect

Ultralow Thermal Conductivity and Enhanced Figure of Merit for CuSbSe2 Via Cd-Doping

Optimizing Thermoelectric Performance of CoSbS0.85Se0.15 by Doping 3d Transition Metal Ions M (M = Cr, Mn, Fe and Ni)

Ultralow Thermal Conductivity and Enhanced Figure of Merit for CuSbSe 2 via Cd-Doping

Enhanced Thermoelectric Performance of BiCuSeO Via Dual-Doping in Both Bi and Cu Sites

Enhancement of the thermoelectric properties of MnSb2Se4 through Cu resonant doping

Enhanced Thermoelectric Performance of Bi–Se Co-Doped Cu1.8S Via Carrier Concentration Regulation and Multiscale Phonon Scattering

Co-precipitation Synthesis of Sn And/or S Doped Nanostructured Cu3Sb1−xSnxSe4−ySy with a High Thermoelectric Performance

Enhanced Thermoelectric Performance of Bi–Se Co-Doped Cu 1.8 S via Carrier Concentration Regulation and Multiscale Phonon Scattering

Synergistic Strategy to Enhance the Thermoelectric Properties of Cosbs1-Xsex Compounds Via Solid Solution

Structural features and thermoelectric performance of Sb- and Bi-doped Cu2SnSe3 compounds

Significantly enhanced thermoelectric figure of merit of n-type Mg3Sb2-based Zintl phase compounds via co-doped of Mg and Sb site

Enhanced Thermoelectric Performance of PbSe Co-Doped with Ag and Sb

Enhanced thermoelectric performance of BiCuSO by Pb doping and Se alloying

High Thermoelectric Properties for Sn-doped AgSbSe 2

Enhanced Thermoelectric Performance of Cu2Se Alloys by Simultaneous Engineering of Thermal and Electrical Transport Properties Through S and Te co‐doping

Achieving high power factor and thermoelectric performance through dual substitution of Zn and Se in tetrahedrites Cu<sub>12</sub>Sb<sub>4</sub>S<sub>13</sub>

Enhanced Thermoelectric Performance of Cu2SnSe3 by Synergic Effects Via Cobalt-Doping

Achieving High Power Factor And Thermoelectric Performance Through Dual Substitution Of Zn And Se In Tetrahedrites Cu12sb4s13