Abstract:Single gap (gas gap 2 mm) bakelite Resistive Plate Chamber (RPC) modules of various sizes from 10 cm \times 10 cm to 1 m \times 1 m have been fabricated, characterized and optimized for efficiency and time resolution. Thin layers of different grades of silicone compound are applied to the inner electrode surfaces to make them smooth and also to reduce the surface resistivity. In the silicone coated RPCs an efficiency > 90% and time resolution \sim 2 ns (FWHM) have been obtained for both the streamer and the avalanche mode of operation. Before fabrication of detectors the electrical properties such as bulk resistivity and surface resistivity of the electrode materials are measured carefully. Effectiveness of different silicone coating in modifying the surface resistivity was evaluated by an instrument developed for monitoring the I-V curve of a high resistive surface. The results indicate definite correlation of the detector efficiency for the atmospheric muons and the RPC noise rates with the surface resistivity and its variation with the applied bias voltage. It was also found that the surface resistivity varies for different grades of silicone material applied as coating, and the results are found to be consistent with the detector efficiency and noise rate measurements done with these RPCs.

A new type of RPC with very low resistive material

Performances of silicone coated high resistive bakelite RPC

Study of timing properties of single gap high-resistive bakelite RPC

Performance study of a bakelite RPC prototype built by new technique of linseed oil coating

Development of linseed oil-free bakelite resistive plate chambers

Measurement of electrical properties of electrode materials for the bakelite Resistive Plate Chambers

A new technique of linseed oil coating in bakelite RPC and the first test results

A New Type of Multielements-Doped, Carbon-based Materials Characterized by High-thermoconductiv ity, Low Chemical Sputtering, Low RES Yield and Exposure to Plasma

Prototype study of $0.1\%\,X_0$ and $\mathrm{MHz/cm^2}$ tolerant Resistive Plate Chamber with Diamond-Like Carbon electrodes

Linearity and rate capability measurements of RPC with semi-insulating crystalline electrodes operating in avalanche mode

Fabrication and characterisation of oil-free large High Pressure Laminate Resistive Plate Chamber

Aging Test of a Real-Size High Rate MRPC for CBM-TOF Wall

A Prototype of a High Rating MRPC

Measurements of the Rate Capability of Various Resistive Plate Chambers

Challenges for RPCs and resistive micropattern detectors in the next few years

The Development and Study of High-Position Resolution (50 micron) RPCs for Imaging X-rays and UV photons

Development of bakelite based Resistive Plate Chambers

Development of Multi-gap Resistive Plate Chamber (MRPC) for medical imaging

Development of Multi-Gap Resistive Plate Chambers with Low-Resistive Silicate Glass Electrodes for Operation at High Particle Fluxes and Large Transported Charges

Development of High-Rate Mrpcs for High Resolution Time-Of-Flight Systems

A new layout about the graphite layers in RPC