Abstract:This paper describes the design and calibration of a highly accurate temperature measurement system for pervasive computing applications. A negative temperature coefficient (NTC) thermistor with high resistance tolerance is interfaced through a conditioning circuit to a 12-bit digital converter of a wireless microcontroller. The system is calibrated to minimize the effect of component uncertainties and achieves an accuracy of ±0.03 °C on average (±0.05 °C in worst cases) in a 5 °C to 45 °C range. The calibration process is based on a continuous temperature sweep, while calibration data are simultaneously logged to reduce the delays and cost of conventional calibration approaches. An uncertainty analysis is performed to support the validity of the reported performance results. The described approach for interfacing the thermistor to the hardware platform can be straightforwardly adjusted for different thermistors, temperature ranges/accuracy levels/resolutions, and voltage ranges. The low power communication combined with the energy consumption optimization adopted enable an operation to be autonomic for several months to years depending on the application's measurement frequency requirements. The system cost is approximately $45 USD in components, while its design and compact size allow its integration with extended monitoring systems in various pervasive computing environments. The system has been thoroughly tested and validated in a field trial concerning a precision agriculture application and is currently used in a health monitoring application.

Non-bridge NTC thermistor anemometer with programmable sensitivity

A BJT-based SAR Temperature Sensor with a $5.12\ \text{pJ}\cdot \mathrm{K}^{2}$ Resolution FoM from -40 °C to 125 °C.

A BJT-Based CMOS Temperature Sensor with Duty-Cycle-Modulated Output and ±0.5°C (3σ) Inaccuracy from −40 °C to 125 °C

A 1.2V Self-Referenced Temperature Sensor with a Time-Domain Readout and a Two-Step Improvement on Output Dynamic Range

A Dynamic-Biased Resistor-Based CMOS Temperature Sensor with a Duty-Cycle-Modulated Output

An Energy-Efficient BJT-Based Temperature Sensor with +/- 0.8 degrees C (3 sigma) Inaccuracy from-50 to 150 degrees C

Improvement of the signal-to-noise ratio of the constant-temperature hot-wire anemometer using the transfer function

Modeling, Characterization and linearization of Negative Temperature Coefficient (NTC) Thermistor and Pressure Sensors

Design of a Negative Temperature Coefficient Temperature Measurement System Based on a Resistance Ratio Model

Thermally Coupled NTC Chip Thermistors: Their Properties and Applications

Design of temperature measurement system guided by thermal dissipation coefficient of NTC thermistor

Micro anemometer by a MEMS compatible lab-on-a-tube technology

A Novel Design Of An NTC Thermistor Linearization Circuit

A simple experiment to determine the characteristics of an NTC thermistor for low-temperature measurement applications

Optimal design and calibration of NTC thermistor based temperature measurement system for high temperature application

Thermally Coupled NTC Disc Thermistors for Power Applications

A High Precision, Wireless Temperature Measurement System for Pervasive Computing Applications

High Sensitive Flexible Hot-Film Sensor for Measurement of Unsteady Boundary Layer Flow

An Untrimmed BJT-Based Temperature Sensor with Dynamic Current-Gain Compensation in 55-Nm CMOS Process

Novel Temperature Drift Compensation for MEMS Thermal Wind Sensors by Heating Power Calibration Circuits

A Hot Film Wind Sensor with Four Constant Temperature Difference Elements Fabricated on Ceramic Substrate