Abstract:This paper addresses the challenges of selecting a suitable method for negative temperature coefficient (NTC) thermistor-based temperature measurement in electronic devices. Although measurement accuracy is of great importance, the temperature calculation time represents an even greater challenge since it is inherently constrained by the control algorithm executed in the microcontroller (MCU). Firstly, a simple signal conditioning circuit with the NTC thermistor is introduced, resulting in a temperature-dependent voltage UT being connected to the MCU’s analog input. Next, a simulation-based approximation of the actual temperature vs. voltage curve is derived, resulting in four temperature notations: for a look-up table principle, polynomial approximation, B equation and Steinhart–Hart equation. Within the simulation results, the expected temperature error of individual methods is calculated, whereas in the experimental part, performed on a DC/DC converter prototype, required prework and available MCU resources are evaluated. In terms of expected accuracy, the look-up table and the Steinhart–Hart equation offer superior results over the polynomial approximation and B equation, especially in the nominal temperature range of the NTC thermistor. However, in terms of required prework, the look-up table is inferior compared to the Steinhart–Hart equation, despite the latter having far more complex mathematical functions, affecting the overall MCU algorithm execution time significantly.

A Novel Design Of An NTC Thermistor Linearization Circuit

A Novel High PSR Voltage Reference with Secondary Temperature Compensation

Development of a Nonlinear Thermal Equivalent Circuit Model for the Digital Valve with Integrated Multiple Coils

Transfer Thermistor's Resistance and Temperature In-phase by Visual Instrument

Design, Analysis, and Hardware Verification of a Linearized Thermistor-Based Temperature Measurement System

Thermally Coupled NTC Chip Thermistors: Their Properties and Applications

A 1.2V Self-Referenced Temperature Sensor with a Time-Domain Readout and a Two-Step Improvement on Output Dynamic Range

Design of a Negative Temperature Coefficient Temperature Measurement System Based on a Resistance Ratio Model

A galvanic isolated evaluation of a NTC thermistor using a logarithmic amplifier

Modeling, Characterization and linearization of Negative Temperature Coefficient (NTC) Thermistor and Pressure Sensors

A 0.8V Capacitively-Biased BJT-Based Temperature Sensor with an Inaccuracy of ±0.4°C ($\mathbf{3}\mathbf{\sigma}$) from −40°C to 125°C in 22nm CMOS

A Novel Method For On-Line Junction Temperature Measurement Of Power Modules

A novel linear temperature thermistor in the xAl2O3-(1-x)CdSnO3 system

Design of temperature measurement system guided by thermal dissipation coefficient of NTC thermistor

A BJT-Based CMOS Temperature Sensor with Duty-Cycle-Modulated Output and ±0.5°C (3σ) Inaccuracy from −40 °C to 125 °C

Algorithm Execution Time and Accuracy of NTC Thermistor-Based Temperature Measurements in Time-Critical Applications

Thermally Coupled NTC Disc Thermistors for Power Applications

An adaptive calibration technique for thermistor with varying temperature coefficient and reference resistance

Linearization of Temperature Sensors (K-Type Thermocouple) Using Polynomial Non-Linear Regression Technique and an IoT-Based Data Logger Interface

Non-bridge NTC thermistor anemometer with programmable sensitivity