Abstract:This paper describes the design and calibration of a highly accurate temperature measurement system for pervasive computing applications. A negative temperature coefficient (NTC) thermistor with high resistance tolerance is interfaced through a conditioning circuit to a 12-bit digital converter of a wireless microcontroller. The system is calibrated to minimize the effect of component uncertainties and achieves an accuracy of ±0.03 °C on average (±0.05 °C in worst cases) in a 5 °C to 45 °C range. The calibration process is based on a continuous temperature sweep, while calibration data are simultaneously logged to reduce the delays and cost of conventional calibration approaches. An uncertainty analysis is performed to support the validity of the reported performance results. The described approach for interfacing the thermistor to the hardware platform can be straightforwardly adjusted for different thermistors, temperature ranges/accuracy levels/resolutions, and voltage ranges. The low power communication combined with the energy consumption optimization adopted enable an operation to be autonomic for several months to years depending on the application's measurement frequency requirements. The system cost is approximately $45 USD in components, while its design and compact size allow its integration with extended monitoring systems in various pervasive computing environments. The system has been thoroughly tested and validated in a field trial concerning a precision agriculture application and is currently used in a health monitoring application.

Modeling, Characterization and linearization of Negative Temperature Coefficient (NTC) Thermistor and Pressure Sensors

Design of a Negative Temperature Coefficient Temperature Measurement System Based on a Resistance Ratio Model

An Inaccuracy of +/- 0.5 degrees C Digital Temperature Sensor From-40 degrees C to 125 degrees C With Curvature Correction

Development of a Nonlinear Thermal Equivalent Circuit Model for the Digital Valve with Integrated Multiple Coils

A 0.8V Capacitively-Biased BJT-Based Temperature Sensor with an Inaccuracy of ±0.4°C ($\mathbf{3}\mathbf{\sigma}$) from −40°C to 125°C in 22nm CMOS

Osmotic Pressure Molar Ratio Measuring System Based on Technology of Linearization

A High Precision, Wireless Temperature Measurement System for Pervasive Computing Applications

A simple experiment to determine the characteristics of an NTC thermistor for low-temperature measurement applications

A Novel Design Of An NTC Thermistor Linearization Circuit

Non-bridge NTC thermistor anemometer with programmable sensitivity

Thermally Coupled NTC Chip Thermistors: Their Properties and Applications

Algorithm Execution Time and Accuracy of NTC Thermistor-Based Temperature Measurements in Time-Critical Applications

Linearization of Temperature Sensors (K-Type Thermocouple) Using Polynomial Non-Linear Regression Technique and an IoT-Based Data Logger Interface

The Influence of Pressure on the TCF of AlN-Based SAW Pressure Sensor

Evaluation of different calibration equations for NTC thermistor applied to high-precision temperature measurement

Design of temperature measurement system guided by thermal dissipation coefficient of NTC thermistor

A novel linear temperature thermistor in the xAl2O3-(1-x)CdSnO3 system

Design, Analysis, and Hardware Verification of a Linearized Thermistor-Based Temperature Measurement System

An adaptive calibration technique for thermistor with varying temperature coefficient and reference resistance

A novel temperature compensated piezoresistive pressure sensor