Abstract:In this study, a sputtering system was adopted for the preparation of Cu2ZnSnS4 (CZTS) thin films with high material quality. The system precisely controlled the elemental ratio in a copper-zinc-tin (CZT) precursor for contributing to the grain growth of CZTS crystallites, and reduced the detrimental formation of the Cu2-xS secondary phase during the high-temperature sulfurization process. The CZT precursor was prepared in a layer sequence of Zn/Sn/Cu/Zn, as the Cu-capping layer could protect the underlying Zn/Sn bilayer from volatilization during the high-temperature sulfurization. The CZT precursors were subjected to the sulfurization process at varied temperatures ranging from 480 to 560 °C for 20 min to form the CZTS thin film. In this study, the Cu/(Zn + Sn) and Zn/Sn ratios in the CZTS film were studied by energy dispersive X-ray spectroscopy measurements, and both ratios revealed elevations with an increasing sulfurization temperature, owing to the thermal volatilization of Zn and Sn. Thus, the formation of the undesirable Cu2-xS secondary phase was enhanced, and the surface roughness and density of voids on the CZTS thin films were increased. For a reduced Zn/Sn ratio with a reduced sulfurization temperature, the improved CZTS thin-film quality was demonstrated by the increased X-ray diffraction (XRD) and Raman intensity, along with the reduction of the XRD linewidth of the (112) CZTS crystal phase. A CZTS thin film with a sulfurization condition of 500 °C for 20 min showed a low Zn/Sn ratio (at 1.1), along with the features of a dense and smooth thin-film surface. Moreover, a reduced photoluminescence spectra full width at half maximum (FWHM) value of 92.7 meV was observed. In addition, for further improving the grain growth of CZTS, a pre-annealing process of a CZT precursor was conducted at a temperature of 350 °C for 30 min. An enhancement of the CZTS crystallite size with the stoichiometric formation of a CZTS phase and a reduced Cu2-XS phase was observed, indicating the superior material quality of the CZTS thin films.

CTZS Thin Films Grown by a Sequential Deposition of Precursors

Substrate and Cu concentration-dependent physical properties of spray-deposited Cu2ZnSnS4 thin films: a comparative study

Facile single-component precursor for Cu2ZnSnS4 with enhanced phase and composition controllability

Single-step Preparation and Characterization of Cu2ZnSn(SxSe1−x)4 Thin Films Deposited by Pulsed Laser Deposition Method

An Investigation on Structural, Morphological, Optical, and Electrical Properties of Copper Zinc Tin Sulfide (CZTS) Thin Films Prepared by SILAR Method

Preparation And Characterization Of Cu2znsns4 Thin Films And Solar Cells Fabricated From Quaternary Cu-Zn-Sn-S Target

Study of optical and structural properties of CZTS thin films using copper capping layer and sulfurization to correct stoichiometry.

Study on the Optimization of Cu-Zn-Sn-O to Prepare Cu2ZnSnS4 Thin Film via a Nano Ink Coating Method

Facile growth of Cu2ZnSn(SSe)4 thin films with controlled phase and microstructure evolution from green ethanol-based molecular solutions

Study of polycrystalline Cu2ZnSnS4 films by Raman scattering

Using Cu–Zn–Sn–O Precursor to Optimize CZTSSe Thin Films Fabricated by Se Doping With CZTS Thin Films

Investigation of Zn/Sn ratio for improving the material quality of CZTS thin films with the reduction of Cu2-xS secondary phase

Deposition of nano-crystalline Cu2ZnSnS4 thin film in one step without sulfurization: Future prospects

Synthesis and characterization of CZTS and Cu2-xAgxZnSnS4 thin films for the application of solar cells

Fabrication of solar cells based on $Cu_2ZnSnS_4$ prepared from $Cu_2SnS_3$ synthesized using a novel chemical procedure

Reaction Time and Film Thickness Effects on Phase Formation and Optical Properties of Solution Processed Cu2ZnSnS4 Thin Films

Towards a promising systematic approach to the synthesis of CZTS solar cells

Effect of sulfurization time on the properties of copper zinc tin sulfide thin films grown by electrochemical deposition

Effect of the stacking order, annealing temperature and atmosphere on crystal phase and optical properties of Cu2SnS3

Optical and Electrical Properties Study of Sol-Gel Derived Cu2znsns4 Thin Films for Solar Cells

Growth Mechanism and Properties of Nanostructure Cu 2 ZnSnSe 4 Thin Films and Solar Cells