Abstract:Based on the in situ diagnostic system and the digital image post-processing technique, quantifications of the anodic erosion components and heat transfer efficiency for tungsten and the W80Ag20 material in arcs of argon, helium, and nitrogen were achieved. The leading vaporization of silver has been found to result in evidently lower anodic heat transfer efficiency and much smaller molten pools compared with those of the tungsten anode, but the intensive generation of silver vapor under the melt layer causes higher splashing erosion of the W80Ag20 anode. However, these characteristics can be strongly changed by the cathodic blowing, which leads to a much higher splashing erosion of tungsten anode but a lower erosion rate of W80Ag20 anode. Through the visualization of the erosion behavior and the post microanalysis of the anode surface, the possible driving mechanisms for the generation of the splashing droplet were discussed. The result indicates that the local high pressure caused by the vapor blasting during the bubble explosion plays a key role in the detachment of splashing droplets. Furthermore, as for the tungsten-based anode, the comparison of erosion behavior between the W80Ag20 anode and the previous-studied W70Cu30 anode makes it clear that increasing the temperature difference between the melting point (MP) of tungsten and the boiling point (BP) of the other material has the pros and cons. It is effective for the decrease of the anode erosion when the anode heat energy is relatively weak, while it can promote the splashing erosion when the liquid tungsten layer has been formed on the anode tip. These results are beneficial for the optimal design of the electrode system in circuit breakers.

Evolution rules for cathode erosion and corresponding arc behaviour in tungsten inert gas welding

Evolution of Anodic Erosion Components and Heat Transfer Efficiency for W and W80Ag20 in Atmospheric-Pressure Arcs

Effect of Oxygen Contamination on Erosion of Tungsten Electrode in Gta Welding

Experimental investigating pure tungsten cathode behavior in argon AC-TIG welding

Experimental Investigation of Electrode Erosion of Trigatron in Microsecond Arc Discharge Process

Effect of Contact Materials on the Transient Characteristics of Vacuum Arc Plasma and Anode Erosion

Electrode Tips Geometry and Penetrating in Narrow Gap Welding

Study on Arc Behavior and Weld Formation of Magnetically Controlled Narrow Gap TIG Welding

Numerical Simulation on the Nonaxisymmetry Arc Characteristics in Narrow Gap TIG Welding: Responses to Welding Parameters

Experimental Study on the Transformation of the W70Cu30 Anode Erosion Mode in DC Gaseous Arcs-Better Insights into Mechanisms of Electrode Erosion Behavior Using in Situ Diagnosis

Effect of droplet transition on arc morphology, Mn evaporation and microstructure during the CMT welding with high nitrogen Cr-Mn steel

Arc Behavior under Extreme Condition

Methods to Improve TIG Welding Efficiency

Influence of Interwire Distance and Arc Length on Welding Process and Defect Formation Mechanism in Double-Wire Pulsed Narrow-Gap Gas Metal Arc Welding

Numerical simulation on molten pool behavior of narrow gap gas tungsten arc welding

Numerical Simulation of Arc Characteristics in K-TIG Welding

Sustaining the Open Keyhole in Slow-Falling Current Edge During K-TIG Process: Principle and Parameters

Simulation of Electrode Erosion under DC Air Arc

2D Self-Consistent Modeling of Arc–electrode Interaction in GTAW Using a Finite Volume Method

Visualization and mechanisms of splashing erosion of electrodes in a DC air arc

Electrode Degradation Mechanism During Resistance Spot Welding of Zinc Coated Steel Using Cu-Tib2 Electrodes