Abstract:Welding polarity has influence on welding stability to some extent, but the specific relationship between welding polarity and weld quality has not been found, especially under the hyperbaric environment. Based on a hyperbaric dry welding experiment system, gas metal arc welding(GMAW) experiments with direct current electrode positive(DCEP) and direct current electrode negative(DCEN) operations are carried out under the ambient pressures of 0.1 MPa, 0.4 MPa, 0.7 MPa and 1.0 MPa to find the influence rule of different welding polarities on welding spatters and weld bead geometry. The effects of welding polarities on the weld bead geometry such as the reinforcement, the weld width and the penetration are discussed. The experimental results show that the welding spatters gradually grow in quantity and size for GMAW with DCEP, while GMAW with DCEN can produce fewer spatters comparatively with the increase of the ambient pressure. Compared with DCEP, the welding current and arc voltage waveforms for DCEN is more stable and the distribution of welding current probability density for DCEN is more concentrated under the hyperbaric environment. When the ambient pressure is increased from 0.1 MPa to 1.0 MPa, the effects of welding polarities on the reinforcement, the weld width and the penetration are as follows: an increase of 0.8 mm for the weld reinforcement is produced by GMAW with DCEN and 1.3 mm by GMAW with DCEP, a decrease of 7.2 mm for the weld width is produced by DCEN and 6.1 mm by DCEP; and an increase of 3.9 mm for the penetration is produced by DCEN and 1.9 mm by DCEP. The proposed research indicates that the desirable stability in the welding procedure can be achieved by GMAW with DCEN operation under the hyperbaric environment.

Effects of electrode polarity on the droplet transfer mode in self-shielded flux-cored arc welding

Effect of polarities and shielding gases in CWW GMAW

Polarities effect on arc interference in triple-electrode CO2 fillet welding

Arc Behavior and Droplet Transfer Analysis in AC-P-MIG Welding of Aluminum Alloys

Arc Properties and Droplet Transfer Characteristics in Cable-Type Welding Wire Electrogas Welding

Welding polarity effects on weld spatters and bead geometry of hyperbaric dry GMAW

Metal Transfer and Arc Behaviour of Novel Consumable and Non-Consumable Electrode Indirect Arc Droplet Welding

Effects of Electrode Negative Pulsing Ratio in Direct Energy Deposition via Variable-Polarity Cold Metal Transfer Process on the Deposition Behavior and Microstructural Characteristics

Effect of Water Flow on the Arc Stability and Metal Transfer in Underwater Flux-Cored Wet Welding

Effect of metal transfer mode on spatter and arc stability in underwater flux-cored wire wet welding

Effect of Forces on Dynamic Metal Transfer Behavior of Cable-Type Welding Wire Gas Metal Arc Welding

Analysis of dynamic force equilibrium on droplet during short-circuiting transfer and process stability

Effects of Shielding Gas Composition on Arc Characteristics and Droplet Transfer in Tandem Narrow Gap Gma Welding

Effect of metal transfers and shielding gases on profiles of high current MAG welding

Investigation on droplet transfer behavior during fiber laser-flux cored arc hybrid welding

Metal transfer characteristics of GMAW with strip electrode

Investigation on the correlation between the selection of polar and heat generation of the anode and cathode during arc welding

Numerical simulation of arc, metal transfer and its impingement on weld pool in variable polarity gas metal arc welding

Modeling and analysis of droplet forming in gas metal arc welding short circuiting transfer

Influence of Laser on the Droplet Behavior in Short-Circuiting, Globular, and Spray Modes of Hybrid Fiber Laser-Mig Welding

Effects of Arc Bubble Behaviors and Characteristics on Droplet Transfer in Underwater Wet Welding Using In-Situ Imaging Method