Abstract:It is a great challenge to improve the process stability in conventional underwater wet welding due to the formation of unstable bubble. In this study, mechanical constraint method was employed to interfere the bubble generated by underwater wet welding, and the new method was named as mechanical constraint assisted underwater wet welding. The aim of the study was to quantify the combined effect of wire feed speed and condition of mechanical constraint on the process stability in mechanical constraint assisted underwater wet welding. Experimental results demonstrated that the introduction of mechanical constraint not only suppressed the bubble without floating but also stabilized the arc burning process. The degree of influence of mechanical constraint, which changed with wire feed speed, played an important role during the mechanical constraint assisted underwater wet welding process. For all wire feed speeds, the fluctuations of welding electrical signal were decreased through introduction of mechanical constraint. The difference in the proportion of arc extinction process between underwater wet welding and mechanical constraint assisted underwater wet welding became less with increasing wire feed speed. At wire feed speed lower than 7.5 m/min, the improvement of process stability was very significant by mechanical constraint. However, the further improvement produced limited effect when the wire feed speed was greater than 7.5 m/min. The observation results showed that a better weld appearance was afforded at a large wire feed speed, corresponding to a lower variation coefficient.

Effects of process parameters on the depth-to-width ratio of flux-cored wire underwater wet welding

Control weld geometric parameters when wet underwater welding

Impact of Process Parameters on Forming Quality and Deposition Efficiency of Unsupported Rods in Wire Arc Additive Manufacturing

Effect of activating fluxes and welding parameters on weld depth to width ratio in A-TIG welding

Effect of Filling Rate on Underwater Wet Welding Process and Weld Appearance

Correlation between wire feed speed and external mechanical constraint for enhanced process stability in underwater wet flux-cored arc welding

Effect of Parameters Change on the Weld Appearance in Stainless Steel Underwater Wet Welding with Flux-Cored Wire

Effects of processing parameters on arc stability and cutting quality in underwater wet flux-cored arc cutting at shallow water

Effect of Water Flow on the Arc Stability and Metal Transfer in Underwater Flux-Cored Wet Welding

Effects of Welding Velocity on Metal Transfer Mode and Weld Morphology in Underwater Flux-Cored Wire Welding

Influence of Interwire Distance and Arc Length on Welding Process and Defect Formation Mechanism in Double-Wire Pulsed Narrow-Gap Gas Metal Arc Welding

Effect of hydrostatic pressure on protective bubble characteristic and weld quality in underwater flux-cored wire wet welding

Effect of arc distance on temperature field and weld shape during double-sided arc welding

The effects of process parameters on melt-pool oscillatory behaviour in gas tungsten arc welding

Effects of Welding Parameters on Droplet Transfer and Bead Geometry in Laser Welding with Aluminum and Stainless Steel Filler Wires

Effect of water depth on weld quality and welding process in underwater fiber laser welding

Effects of Torch Configuration on Arc Interaction Behaviors and Weld Defect Formation Mechanism in Tandem Pulsed GMAW

Effects of Welding Speed on Bubble Dynamics and Process Stability in Mechanical Constraint-Assisted Underwater Wet Welding of Steel Sheets

Effects of Processing Parameters on Molten Behavior, Arc Stability, and Defect Forming in Swing-Arc Narrow Gap GMA Vertical Up Welding

The Efficiency of Thermite-Assisted Underwater Wet Flux-Cored Arc Welding Process: Electrical Dependence, Microstructural Changes, and Mechanical Properties

Control Of Droplet Transition In Underwater Welding Using Pulsating Wire Feeding