Abstract:The aim of this investigation is to offer a data-based scheme for predicting electrode wear in resistance spot welding. One of the major factors affecting the mechanical properties of spot welds and the variation in weld quality is electrode wear and alloying. In this study, Rogowski coils and twisted pairs attached to the top and bottom electrodes were used to obtain the welding current and the voltage between the electrodes in the welding process, thereby calculating the dynamic resistance value during the welding process. The electrode tip diameter was obtained from the pressure exerted by the upper and lower electrodes on the carbon paper when the current was cut off and was regarded as an indicator of electrode wear. By continuously welding 0.5 mm thick BH 340 steel plates until the electrode failed, the dynamic resistance signal was recorded in real time. Simultaneously, the electrode diameter after every several welds was also recorded. On this basis, the correlation between electrode tip diameter and dynamic resistance is studied. In order to quantitatively study the mapping relationship between dynamic resistance and electrode wear, 10 characteristic values were extracted from the dynamic resistance, and the stepwise regression method was used to obtain the regression formula between the characteristic values and the electrode tip diameter. Using new data to verify the effectiveness of the regression model, the acquired results display that the maximum error between the predicted value of the electrode tip diameter and the measured value obtained by the regression equation with the interactive quadratic term is 0.3 mm, and the corresponding relative error is 7.69%. When welding with a new pair of electrodes, the maximum absolute error was 0.72 mm, and the relative error of the model prediction is within 20% according to the linear regression model with interaction terms. This indicates that this regression model is barely satisfactory for monitoring electrode condition.

Electrode Degradation Mechanism During Resistance Spot Welding of Zinc Coated Steel Using Cu-Tib2 Electrodes

Experimental Study on Electrode Wear Mechanism in Resistance Spot Welding of High Strength Hot Galvanization Steels

Performance and Microstructure of TiN/Cu EDM Electrodes

Effect of Inserted Strips on Electrode Degradation in Resistance Spot Welding

Characteristics of Electrode Wear in Resistance Spot Welding Dual-Phase Steels

Effect of a slightly concave electrode on resistance spot welding of Q&P1180 steel

Assessing Electrode Characteristics in Continuous Resistance Spot Welding of BH 340 Steel Based on Dynamic Resistance

Monitoring and intelligent control of electrode wear based on a measured electrode displacement curve in resistance spot welding

Mechanical properties and wear resistance of aluminum composite welded by electron beam

Particle Strengthening of the Surface of Copper Electrode for Electrical Discharge Machining

Effect of Electrode Wear on Weld Nugget Formation in Resistance Spot Welding of Magnesium Alloy

Characteristics of Electrode Wear in Spot Welding of Hot Galvanized Dual-Phase High Strength Steel

EDM Performance of Electroformed Cu‐ZrB2 Shell Electrodes

EDM performance of electroformed Cu‐ZrB<sub>2</sub> shell electrodes

Flux Filling Rate Effect on Weld Bead Deposition of Recycled Titanium Chip Tubular Wire

A Study on the Weldability of Automotive Galvanized Steel Sheet in Resistance Spot Welding

Electroforming of copper/ZrB2composite coating and its performance as electro-discharge machining electrodes

Electroforming of Copper/ZrB<sub>2</sub> Composites Coatings and Its Performance as Electro-Discharge Machining Electrodes

Microstructural features and mechanical properties of in-situ remelting welding of TC4 titanium alloy and T2 copper welded joint by electron beam

Achieving Superior Corrosion Resistance of TiB2 Reinforced Al-Zn-Mg-Cu Composites via Optimizing Particle Distribution and Anodic Oxidation Time

Effects of electrode wear on weld quality of hot galvanization steel with high strength in resistance spot welding