Abstract:For low costs, numerical simulation is an effective method to reveal the internal mechanisms inside a thermal plasma torch. Various simulation models for studying the inside or outside characteristics of thermal plasma torches have been built and discussed. However, to reveal the inside mechanisms of thermal plasma torches under various working conditions to support the materials processing, more attention should be paid to building precise models of laminar plasma torches. Thus, based on the user-defined function (UDF) and user-defined scalar (UDS) of ANSYS Fluent software, the assumptions, governing equations, boundary conditions, and solving method were discussed in detail, and a corresponding numerical model of a homemade laminar plasma torch was first built. For verifying the effectiveness of the proposed numerical model and studying the influence of the gas components on the arc characteristics, the working conditions and experimental setups were introduced in sequence. Finally, the numerical and experimental results of the homemade laminar plasma torch were obtained and discussed in detail. The study results show that: 1 The axial temperature of the plasma torch could be divided into three sections along the axis: peak temperature area (10 mm < x < 20 mm), stable temperature area (20 mm < x < 62 mm) and decrease temperature area (62 mm < x < 95 mm). Under the same input conditions, when pure argon gas was used, the peak temperature at the outlet was reached at approximately 7590 K, while for pure nitrogen and 50%Ar + 50%N2, the corresponding peak temperatures were 6785 K and 7402.2 K, respectively. 2 The axial velocity of pure nitrogen is much higher than that of pure argon and 50%Ar + 50%N2, while that of pure argon and 50%Ar + 50%N2 has little difference. In addition, when nitrogen gas was used, the peak velocity at the outlet reached 185 m/s, whereas, for argon gas and 50%Ar + 50%N2, the corresponding peak velocities were 146 m/s and 169 m/s, respectively. 3 The simulated arc voltage trends under different working conditions are well in accordance with the experimental arc voltage trends.

2D Self-Consistent Modeling of Arc–electrode Interaction in GTAW Using a Finite Volume Method

A Theoretical Model of Arc Light Radiation Based on GTA Spectral Diagnosis

3D Numerical Investigation of a Free-Burning Argon Arc with Metal Electrodes Using a Novel Sheath Coupling Procedure

Two-dimensional self-consistent numerical simulation of the whole discharge region in an atmospheric argon arc

A 2-D Axisymmetric Magneto-Hydrodynamic Model of a DC Arc Plasma Torch and Its Solution Methodology

Two-temperature modeling of lamellar cathode arc

Numerical Study of Plasma–Electrode Interaction During Arc Discharge in a DC Plasma Torch

Computer Intelligent Numerical Simulation of TIG Welding Using Platy Tungsten Electrode

Finite volume simulation of arc: pinching arc plasma by high-frequency alternating longitudinal magnetic field

Effect Of A Near-Cathode Sheath On Heat Transfer In High-Pressure Arc Plasmas

Chemical Non-equilibrium Simulation of Anode Attachment of an Argon Transferred Arc

Effect of Cathode-Plasma Coupling on Plasma Torch Operation Predicted by a 3D Two-Temperature Electric Arc Model

Two-Dimensional, Non-Equilibrium Modeling of a Gas Tungsten Arc

Non-equilibrium Modelling of Free-Burning Argon Arc in Different Anode Sheath Regimes

Numerical simulation of the arc pressure in gas tungsten arc welding

Three-Dimensional Non-equilibrium Modeling on the Characteristics of the Dual-Jet Direct-Current Arc Plasmas

Two-dimensional modelling of a DC arc plasma furnace with opposite cathode and anode

Numerical simulation on molten pool behavior of narrow gap gas tungsten arc welding

Modeling of the Arc Characteristics inside a Thermal Laminar Plasma Torch with Different Gas Components

Heat transfer and fluid flow in a high-intensity free-burning arc: an improved modeling approach

A theoretical study of a gas metal arc welding system