Abstract:N‐type Mg3Sb2‐based material is recognized as a promising thermoelectric material. Ag is revealed as an effective dopant for the Mg3.2Sb1.5Bi0.49Te0.01 system with a different effect from Cu. A peak ZT of 1.64 at 673 K is achieved. Moreover, a 2‐pair module fabricated with MgAgSb as p‐type material, results in a high ηmax of ≈7.9% at relatively low ΔT of 277 K. The n‐type Mg3(Sb, Bi)2 compounds show great potential for wasted heat energy harvesting due to their promising thermoelectric properties. This work discovers that doping transition element Ag into the n‐type Mg3(Sb, Bi)2 can effectively optimize the power factor and suppress the lattice thermal conductivity simultaneously. Interestingly, the Ag doping has different effects compared to the isoelectronic and same group element Cu addition studied previously. A high power factor of 19.6 μW cm−1 K−2 is obtained at 673 K owing to the increased electrical conductivity. At the same time, the lattice thermal conductivity is reduced to ≈0.5 W m−1 K−1 because of enhanced phonon scattering induced by Ag atoms. These improvements lead to a peak figure of merit (ZT) of 1.64 at 673 K as well as a high average ZT of 1.27 is obtained from 323 K to 673 K. Furthermore, a thermoelectric single leg with a competitive conversion efficiency of ≈11% under a hot‐side temperature of 673 K is fabricated successfully. In addition, a 2‐pair module composed of n‐type Mg3(Sb, Bi)2 alloy and p‐type MgAgSb‐based compound demonstrates the high conversion efficiency of ≈7.9% at a temperature difference of 277 K, which will significantly upgrade the sustainable energy recycling technology.

Synergistic effects of Mg vacancy and Ag doping on thermoelectric transport properties of p-type Mg3Sb2

Ag-Mg antisite defect induced high thermoelectric performance of α-MgAgSb

Thermoelectric performance improvement of p-type Mg3Sb2-based materials by Zn and Ag co-doping

Thermoelectric performance enhancement of Pb-doped α -MgAgSb near room temperature

Realizing high thermoelectric performance in p-type CaZn2Sb2-alloyed Mg3Sb2-based materials via band and point defect engineering

Excellent Room Temperature Thermoelectric Performance in Mg3Sb2‐Based Alloys via Multi‐Functional Doping of Nb

Realizing Cd and Ag codoping in p-type Mg3Sb2 toward high thermoelectric performance

Improvement of the Thermoelectric Properties of p-Type Mg 3 Sb 2 by Mg-Site Double Substitution

Mg Vacancy and Dislocation Strains As Strong Phonon Scatterers in Mg2Si1−xSbx Thermoelectric Materials

Charge compensation weakening ionized impurity scattering and assessing the minority carrier contribution to the Seebeck coefficient in Pb-doped Mg3Sb2 compounds

Enhancing the Thermoelectric Performance of Mg2Sn Single Crystals Via Point Defect Engineering and Sb Doping.

Optimization of the thermoelectric performance of α-MgAgSb-based materials by Zn-doping

Robust Room Temperature Thermoelectric Performance of Mg3(Sb, Bi)2‐Based Alloys via Multivalent Mn Doping

Improving p-type thermoelectric performance of Mg2(Ge,Sn) compounds via solid solution and Ag doping

Enhanced Average Thermoelectric Figure of Merit of p-Type Zintl Phase Mg 2 ZnSb 2 via Zn Vacancy Tuning and Hole Doping

Unusual Consequences of Donor and Acceptor Doping on the Thermoelectric Properties of the MgAg0.97Sb0.99 Alloy

Enhancing the Thermoelectric Performance of n‐Type Mg3Sb2‐Based Materials via Ag Doping

Realizing Excellent Structural and Thermoelectric Performance in Mg 3 Sb 2 -Based Alloys by Manipulating Mg Intrinsic Migration Kinetics with Interstitial Ni Doping

Multiscale Defects as Strong Phonon Scatters to Enhance Thermoelectric Performance in Mg2Sn1-xSbx Solid Solutions

Role of Pb doping on the thermoelectric properties of Mg3Sb1.8‐yBi0.2Pby alloys

Electronic Orbital Alignment and Hierarchical Phonon Scattering Enabling High Thermoelectric Performance p-Type Mg 3 Sb 2 Zintl Compounds