Abstract:Due to the rich reserves of the raw materials, along with their low cost and nontoxic nature, Mg2Si1−xSnx-based compounds have generated intense attention from the international thermoelectric community for their application in thermoelectric power generation within the intermediate temperature range. In this work, we have adopted a two-step solid state reaction followed by a spark plasma sintering process to prepare a series of Sb-doped Mg2.16(Si0.4Sn0.6)1−ySby (0 ≤ y ≤ 0.055) solid solutions. We discuss the influence of Sb doping and the microstructure on the thermoelectric properties. Our results confirm that Sb acts as an effective n-type dopant and we estimate the maximum amount of Sb the Mg2Si0.4Sn0.6 structure can accommodate to be ∼2.3% by XRD, DSC and EPMA analyses. The electron transport properties and low-temperature electronic heat capacity measurements reveal that both the light conduction band and the heavy conduction band contribute to the transport in n-type Mg2Si0.4Sn0.6 solid solutions. The highest density-of-states effective mass and power factor were observed for Mg2.16(Si0.4Sn0.6)0.985Sb0.015 with an electron concentration of n ≈ 1.67 × 1020 cm−3, which is likely to be due to the Fermi level positioned within ∼2kBT of both the heavy and light conduction bands providing contributions from both bands. In addition, doping with Sb does not seem to affect the lattice thermal conductivity above room temperature. TEM analysis indicates the presence of Sn-rich precipitates with the size of several tens of nanometers dispersed in the Mg2Si0.4Sn0.6 matrix. Such a nanophase may enhance the boundary scattering of phonons and contribute to a low lattice thermal conductivity. Owing to the above characteristics of the band structure and the microstructure, the Mg2.16(Si0.4Sn0.6)0.985Sb0.015 solid solution with n = 1.67 × 1020 cm−3 possessed excellent thermoelectric properties and achieved a high ZT value of 1.3 at 740 K. Further reductions in the lattice thermal conductivity could be achieved via optimization of the nanophase inclusions, leading to a further enhancement of the figure of merit for Mg2Si0.4Sn0.6-based solid solutions.

Enhanced Average Thermoelectric Figure of Merit of p-Type Zintl Phase Mg 2 ZnSb 2 via Zn Vacancy Tuning and Hole Doping

Significantly enhanced thermoelectric properties of p-type Mg3Sb2 via co-doping of Na and Zn

Significant Role of Mg Stoichiometry in Designing High Thermoelectric Performance for Mg3(Sb,Bi)2-Based N-Type Zintls.

Na/Bi-co-doping and Heterogeneous Interfaces Leading to Enhanced Thermoelectric Performance of P-Type Mg3Sb2-based Zintls

Enhanced thermoelectric performance of p -type Mg 3 Sb 2 by lithium doping and its tunability in an anionic framework

Enhanced Thermoelectric Performance in P-Type Mg 3 Sb 2 Via Lithium Doping

Thermoelectric performance improvement of p-type Mg3Sb2-based materials by Zn and Ag co-doping

Significantly Enhanced Thermoelectric Performance of p -Type Mg 3 Sb 2 via Zn Substitution on Mg(2) Site: Optimization of Hole Concentration Through Ag Doping

Electronic Orbital Alignment and Hierarchical Phonon Scattering Enabling High Thermoelectric Performance p-Type Mg 3 Sb 2 Zintl Compounds

Electronic Orbital Alignment and Hierarchical Phonon Scattering Enabling High Thermoelectric Performance P-Type Mg3Sb2 Zintl Compounds

Extraordinary Thermoelectric Performance in N-Type Manganese Doped Mg3Sb2 Zintl: High Band Degeneracy, Tuned Carrier Scattering Mechanism and Hierarchical Microstructure

Enhancing the Thermoelectric Performance of P-Type Mg3Sb2 Via Codoping of Li and Cd

Synergistic Effect of Band and Nanostructure Engineering on the Boosted Thermoelectric Performance of n‐Type Mg3+δ(Sb, Bi)2 Zintls

Enhancing thermoelectric performance of AB 2 Sb 2 -type Zintl phase through band shaping and lattice distortion

Realizing Cd and Ag codoping in p-type Mg3Sb2 toward high thermoelectric performance

Improvement of the Thermoelectric Properties of P-Type Mg3Sb2 by Mg-Site Double Substitution

Excellent thermoelectric performance of boron-doped n-type Mg3Sb2-based materials via the manipulation of grain boundary scattering and control of Mg content

Realizing high thermoelectric performance in p-type CaZn2Sb2-alloyed Mg3Sb2-based materials via band and point defect engineering

Enhancing Thermoelectric Performance of AB2Sb2-type Zintl Phase Through Band Shaping and Lattice Distortion

Enhanced Thermoelectric Properties of N-Type Mg2.16(Si0.4Sn0.6)1−ySby Due to Nano-Sized Sn-rich Precipitates and an Optimized Electron Concentration

Optimization of the thermoelectric performance of α-MgAgSb-based materials by Zn-doping