Abstract:Herein, we report a reproducible improvement of the thermoelectric performance in BiSbTe alloy via kinetically and dynamically regulating excitation behavior in the intrinsic excitation regime. Doping with Pb increases the carrier concentration to the optimal value, kinetically pushing the onset temperature for the intrinsic excitation from 350 K for Bi0.46Sb1.54Te3 sample to 450 K for Pb0.01(Bi0.46Sb1.54)0.995Te3 sample. Moreover, the refined grains, nanostructures as well as dense dislocations induced by the melt-spinning process not only lower the lattice thermal conductivity via intensifying the interfacial phonon scattering but also selectively block the migration of minority carrier, modifying the dynamic process of the charge carrier and resulting in a smaller ratio of ( μ e / μ h ). This improves the power factor in the measured temperature range and suppresses the bipolar thermal conductivity in the intrinsic excitation regime. Thus, a maximum power factor of 4.44 mW m−1 K−2 and the lowest thermal conductivity of 1.06 W m−1 K−1 are attained for the sample with refined grains and nanostructures. All these contribute to the highest ZT value of 1.31 at 380 K and the highest average ZT value of 1.17 from 300 K to 500 K for Pb0.002(Bi0.46Sb1.54)0.999Te3 sample. This improved thermoelectric property was further verified in a thermoelectric module with the conversion efficiency of 4.38 % under a temperature gradient of 175 K, which is 20 % higher than that of the commercial ZM-based module under the same temperature gradient.

Role of Pb doping on the thermoelectric properties of Mg3Sb1.8‐yBi0.2Pby alloys

Effects of Bi alloying on thermoelectric properties of p‐type Mg3Sb2‐xBix solid solutions

Effects of Bi Alloying on the Thermoelectric Properties of P‐type Mg3Sb2‐xBix Solid Solutions

Enhanced Thermoelectric Performance in P-Type Mg 3 Sb 2 Via Lithium Doping

Charge compensation weakening ionized impurity scattering and assessing the minority carrier contribution to the Seebeck coefficient in Pb-doped Mg3Sb2 compounds

Effects of Bi and Sb Doping on the Thermoelectric Performance of N-Type Quaternary Mg2.18Ge0.1Si0.3Sn0.6 Materials

Tuning the Carrier Scattering Mechanism to Improve the Thermoelectric Performance of P-Type Mg3Sb1.5Bi0.5-based Material by Ge Doping

Roles of concentration-dependent Cu doping behaviors on the thermoelectric properties of n-type Mg3Sb1.5Bi0.5

Enhanced thermoelectric performance of n-type Mg3Bi2-based materials by Se doping and alloying engineering

Effect of Composition Adjustment on the Thermoelectric Properties of Mg3Bi2-Based Thermoelectric Materials

Enhancing the Thermoelectric Performance of P-Type Mg3Sb2 Via Codoping of Li and Cd

Thermoelectric Properties of Zn-Doped YbMg1.85−xZnxBi1.98

Extraordinary thermoelectric performance, thermal stability and mechanical properties of n-type Mg3Sb1.5Bi0.5 through multi-dopants at interstitial site

High performance of Mg3Bi1.5Sb0.5 based materials for power generation: Revealing the counter-intuitive effect of tuning Bi content on the thermoelectric properties

Thermoelectric performance improvement of p-type Mg3Sb2-based materials by Zn and Ag co-doping

Thermoelectric performance enhancement of Pb-doped α -MgAgSb near room temperature

Improvement of the Thermoelectric Properties of P-Type Mg3Sb2 by Mg-Site Double Substitution

Enhanced thermoelectric performance of p -type Mg 3 Sb 2 by lithium doping and its tunability in an anionic framework

Regulation of exciton for high thermoelectric performance in (Bi, Sb)2Te3 alloys via doping with Pb and multi-scale microstructure

Realizing Cd and Ag codoping in p-type Mg3Sb2 toward high thermoelectric performance

Influence of Sb Doping on Thermoelectric Properties of Mg2Ge Materials