Abstract:An increase in hydrostatic stress improves the plasticity of metallic materials. However, for some special components, such as large thin-walled components with high ribs, excessive hydrostatic stress can cause several problems that make it impossible to prepare such components using plastic forming methods. In this study, the effect of hydrostatic stress on the deformation behavior of large thin-walled components with high ribs was investigated using a combination of numerical simulations and theoretical derivations. The results indicated that excessive hydrostatic stress leads to die failure, causing metal flow difficulties, uneven deformation, inconsistent mechanical properties, and reduced forming accuracy. Therefore, a low-hydrostatic-stress extrusion method was proposed by adjusting the contact friction, metal flow direction and displacement, and force boundary conditions to reduce the hydrostatic compressive stress. These principles are mainly reflected in the following three aspects: First, the size of the difficult deformation zone was reduced by changing the friction conditions from dry friction to fluid friction or boundary friction to reduce the frictional resistance. Second, the high-stress zone was eliminated by changing the metal flow direction, adjusting the strain state from unidirectional to multi-directional flow, shortening the metal flow path, and reducing the metal flow resistance. Third, the strong compressive stress state in the three directions was weakened by regulating the force boundary conditions and changing the loading method from one-way extrusion to multi-directional loading. Based on these principles, a series of new forming technologies have been developed, such as actively counteracting frictional resistance, slotting, and ditching on dies for long-lasting lubrication, multi-directional short-range metal flow, drawing-assisted extrusion, and multi-directional active loading. The adoption of these technologies realizes the labor-efficient formation of large thin-walled components with high ribs and provides the formed members with high precision and uniform mechanical properties.

Compression-torsion forming experiment and die design

Design of Hydraulic Bulging Die for Automobile Torsion Beam and Optimization of Forming Process Parameters

Experimental study on centrifuge concrete filled thin-walled steel tubular components under the action of torsion

Research and Development of Ultrafine-Grained Materials Fabricated by Cyclic Extrusion Compression

Study of Microstructure and Mechanical Properties by Torsional Behavior in Axial Closed Die Rolling Forming

Research on a Hydro-Pressing Process of Tubular Parts in an Open Die

Die Design for Cylinder-shaped and Thin-walled Part

Experimental Research on Deformation and Dimensional Accuracy of Rectangular-Section Tubular Part During Open Die Hydro-Pressing Process

Strength Design and Structural Optimization of Cold Extrusion Die for Cylindrical Workpieces

Preforming-die Design and Friction Changing to Control the Thickness Distribution of TC4 Deep Cylinder by Superplastic Forming

Hydroforming of an Automotive Torsion Beam with 780 MPa Advanced High Strength Steel

Effect of Cold Pressing Deformation on Microstructure and Residual Stress of 7050 Aluminum Alloy Die Forgings

A Novel Design of a High-Strength High-Temperature Graphite Die

Experimental Study on Effect of Thermal Deformation Parameters on Forming Process of Microgears

Experiments for Novel Hydro-Mechanical Deep Drawing Die

Investigation on low hydrostatic stress extrusion technology for forming of large thin-walled components with high ribs

Size Effect of Tribology Behaviour in Micro U-Deep Drawing with T2 Copper Foil

Optimization of Die Design for Thin-Walled Flat Multi-Port Tube with the Aid of Finite Element Simulation

Metastructure with Torsion-Compression Coupling Behaviors: Additive-manufacturing, Experimental and Numerical Investigations

Hot micro-extrusion experimentation and die design

STUDY ON THE NUMERICAL SIMULATION OF MULTI-STAGE ROTARY FORGING OF A NON-AXISYMMETRIC PART AND THE CAE ANALYSIS OF THE DIE STRENGTH