Abstract:An increase in hydrostatic stress improves the plasticity of metallic materials. However, for some special components, such as large thin-walled components with high ribs, excessive hydrostatic stress can cause several problems that make it impossible to prepare such components using plastic forming methods. In this study, the effect of hydrostatic stress on the deformation behavior of large thin-walled components with high ribs was investigated using a combination of numerical simulations and theoretical derivations. The results indicated that excessive hydrostatic stress leads to die failure, causing metal flow difficulties, uneven deformation, inconsistent mechanical properties, and reduced forming accuracy. Therefore, a low-hydrostatic-stress extrusion method was proposed by adjusting the contact friction, metal flow direction and displacement, and force boundary conditions to reduce the hydrostatic compressive stress. These principles are mainly reflected in the following three aspects: First, the size of the difficult deformation zone was reduced by changing the friction conditions from dry friction to fluid friction or boundary friction to reduce the frictional resistance. Second, the high-stress zone was eliminated by changing the metal flow direction, adjusting the strain state from unidirectional to multi-directional flow, shortening the metal flow path, and reducing the metal flow resistance. Third, the strong compressive stress state in the three directions was weakened by regulating the force boundary conditions and changing the loading method from one-way extrusion to multi-directional loading. Based on these principles, a series of new forming technologies have been developed, such as actively counteracting frictional resistance, slotting, and ditching on dies for long-lasting lubrication, multi-directional short-range metal flow, drawing-assisted extrusion, and multi-directional active loading. The adoption of these technologies realizes the labor-efficient formation of large thin-walled components with high ribs and provides the formed members with high precision and uniform mechanical properties.

Experimental Research on Deformation and Dimensional Accuracy of Rectangular-Section Tubular Part During Open Die Hydro-Pressing Process

Analysis and experiment on tube hydroforming in a rectangular cross-sectional die

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Buckling and springback behavior in hydro-pressing of thin-walled 5A06 aluminum alloy tubular component

Effect of Internal Pressure Distribution on Thickness Uniformity of Hydroforming Y-shaped Tube

Research on the hydroforming law of variable cross-section shaped tubular automobile longitudinal arm

Influence of Process Parameters on Thinning Ratio and Fittability of Bellows Hydroforming

Investigation on low hydrostatic stress extrusion technology for forming of large thin-walled components with high ribs

Improving the Quality of Hot Stamping Parts with Innovative Press Technology and Inline Process Control

Experimental and Numerical Investigation on the Square Hole Hydro-Piercing Process

Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers

Effects of preform on thickness distribution of hydroformed Y-shaped tube

Push-bending Process of Stainless-Steel Tubes: Experiment and Simulation

Analysis of the wall thickness distortion in tube hydro-forging

Finite Element Analysis and Experimental Study of Manufacturing Thin-Walled Five-Branched AISI 304 Stainless Steel Tubes with Different Diameters Using a Hydroforming Process

Design of Hydraulic Bulging Die for Automobile Torsion Beam and Optimization of Forming Process Parameters

Numerical and experimental investigation on precision forming of ribbed tube by cold drawing process

Process window calculation and pressure locus optimization in hydroforming of conical box with double concave cavities

Numerical and experimental analysis of the isothermal high temperature pneumoforming process

Development of Experimental Method to Improve Sheet Metal Formability by Transverse Normal Stress

Investigation of forming defects in 5A06 aluminum alloy cold stamping of thin-walled shell with corner