Abstract:Diamond-Like Carbon (DLC) is thought to be a potential material in solving heat dissipation problems in light emitting diode module packages. It is of vital importance in evaluating the thermal conductivity of DLC film deposited on a silicon substrate. In this paper, the molecular dynamics method is used to simulate the formation of a DLC film by the deposition of carbon atoms on a isilicon substrate. Tersoff potential is adopted to reproduce the structures and densities of silicon, carbon, and SiC. A silicon substrate consisting of 544 atoms is located at the bottom of the simulation domain. The substrate is kept at a temperature of 600 K through a Noose-Hover thermostat. Carbon atoms are injected into the substrate individually every 0.5 ps at an energy of 1 eV. After a 7.5 ns deposition process, a 4 nm amorphous film containing 15000 carbon atoms is formed. Injected carbon atoms and substrate silicon atoms are intermixed at the bottom layer of the deposited film while the rest of the film contains only carbon atoms. The density of the film decreases slightly with the increase of the height of the deposited film and the average density is 2.8 g/cm3. Analysis of the coordination number shows that the sp3 fraction of carbon atoms in the film also decreases with the increase of the height of the deposited film, with a maximum value of 22%. It might be caused by the continuous impacts of the subsequently injected carbon atoms on the previously formed DLC film. The thermal conductivities of the DLC film in the planar and normal directions are calculated by the Green-Kubo method. The thermal conductivity of pure diamond film is also calculated for comparison. The results show that the planar thermal conductivity of the deposited DLC film is approximately half of that of the pure diamond film with the same size. It is higher than the normal thermal conductivity of the deposited film. The thermal conductivities of the DLC film in both planar and normal directions increase with the increase of film density and sp3 fraction in the DLC film. The results indicate that the local tetrahedral structure of sp3 carbon atoms contributes to the improvement of thermal conductivity in the DLC film.

Diamond-like carbon/Cu composite films on stainless steel: synthesis and investigation of heat transfer properties

Diamond-like Carbon Film on 20 CrNiMo Steel Prepared by Hollow-Cathode Glow Discharge

Preparation and characterization of diamond-like carbon (DLC) film on 316L stainless steel by microwave plasma chemical vapor deposition (MPCVD)

Diamond-Like Carbon Thin Films Deposited On Ti6al4v Alloy Surface By Plasma Gun At Atmospheric Pressure

Deposition of DLC Film on Stainless Steel Substrates Coated by Nickel Using PECVD Method

Effect of Molybdenum Concentration and Deposition Temperature on the Structure and Tribological Properties of the Diamond-like Carbon Films

Properties of Diamond-like Tungsten-Doped Carbon Coatings Lubricated with Cutting Fluid

Structural Characters and Tribological Properties of Diamondlike Carbon Films

Diamond-like Carbon Film Synthesized by Ion Beam Assisted Deposition and Its Tribological Properties

Ion Beam Assisted Deposition of Diamond-Like Carbon Onto Steel Materials: Preparation and Advantages

Comprehensive structural, nanomechanical and tribological evaluation of silver doped DLC thin film coating with chromium interlayer (Ag-DLC/Cr) for biomedical application

A study of the wear mechanism of diamond-like carbon films

Micro-structural, electrical, and tribological properties of SiC/DLC composite coating grown by PLD on steel

On the adhesion of diamond‐like carbon coatings deposited by low‐pressure plasma on 316L stainless steel

X-Ray Photoelectron Spectroscopy of TixAl and TixAl/A-Si:H Interlayer with Different Thicknesses on Stainless Steel to Enhancing Adhesion of DLC Films

In vivo biocompatibility of diamond-like carbon films containing TiO2 nanoparticles for biomedical applications

Diamond-like carbon film from liquid gas on metallic substrates

A temperature-based synthesis and characterization study of aluminum-incorporated diamond-like carbon thin films

Enhancement of tribological properties by dynamic mixing of diamond-like carbon/Mo films on steel

Dep Osition and Thermal Conductivity of Diamond-Like Carb on Film on a Silicon Substrate

Investigation of the Mechanical and Tribological Properties of Diamond-Like Carbon Films on YG8 and High-Speed Steel Substrates with W Buffer Layers