Abstract:Nd3+-doped fiber lasers at around 900 nm based on the F-4(3/2)-> I-4(9/2) transition have obtained much research attention since they can be used as the laser sources for generating pure blue fiber lasers through the frequency doubling. Here, an all-fiber laser at 915 nm was realized by polarization-maintaining Nd3+-doped silica fiber. A net gain per unit length of up to 1.0 dB/cm at 915 nm was obtained from a 4.5 cm fiber, which to our best knowledge is the highest gain coefficient reported in this kind of silica fiber. The optical-to-optical conversion efficiency varies with the active fiber length and the reflectivity of the output fiber Bragg grating (FBG), presenting an optimal value of 5.3% at 5.1 cm fiber length and 70% reflectivity of the low reflection FBG. Additionally, the linear distributed Bragg reflector short cavity was constructed to explore its potential in realizing single-frequency 915 nm fiber laser. The measurement result of longitudinal-mode properties shows it is still multi-longitudinal mode laser operation with 40 mm laser cavity. These results indicate that the Nd3+-doped silica fiber could be used to realize all-fiber laser at 915 nm, which presents potential to be the seed source of high-power fiber laser.

High-peak-power nanosecond pulse laser at 915 nm based on all-fiber structure

Fiber-solid, Hybrid, Single-Frequency Laser (100 W) with a 100 MHz Repetition Rate and 1 Ns Pulse Width from a Spherical Aberration Compensated Four-Stage Nd:YVO4 Amplifier

High Energy and High Power Single Frequency 1572 nm Laser With an All-Fiber MOPA

A 102 W High-Power Linearly-Polarized All-Fiber Single-Frequency Laser at 1560 Nm

Three-level all-fiber laser at 915 nm based on polarization-maintaining Nd<SUP>3+</SUP>-doped silica fiber

High Energy (100 Mj) and High Peak Power (8 MW) Nanosecond Pulses Delivered by Fiber Lasers and Self-Focusing Analysis Based on a Novel Mode Decomposition Method

High-Power Highly Linear-Polarized Nanosecond All-Fiber Mopa at 2040 Nm

High-power, 474 Fs, 31.12 MHz, All-Polarization-maintaining, 1560 Nm Fiber Laser System Based on the Chirped-Pulse Amplification

High-peak-power, single-frequency, single-mode, linearly polarized, nanosecond all-fiber laser based on self-phase modulation compensation

An All Fiber 1.94 Μm Nanosecond Pulse Laser Amplified by Highly Tm 3+ -Doped Silicon Fibers

700 W single-frequency all-fiber amplifier at 1064 nm with kHz-level spectral linewidth

High Peak Power and High Beam Quality Fiber-Solid Hybrid Amplification Laser System

Investigations of the High-Power, Single-Frequency, Sub-Microseconds, 1548-nm Fiber Laser Based on the Optical Pulse Modulation

188 W Nanosecond Pulsed Fiber Amplifier at 1064 Nm

316 W High-Brightness Narrow-Linewidth Linearly-Polarized All-Fiber Single-Frequency Laser at 1950 Nm

High Peak-Power and Narrow-Linewidth All-Fiber Raman Nanosecond Laser in 1.65 Μm Waveband.

High Energy and High Peak Power Nanosecond Pulses Generated by Fiber Amplifier

100 MW Peak Power Picosecond Laser Based on Hybrid End-Pumped Nd:YVO4 and Side-Pumped Nd:YAG Amplifiers

4.115kW near diffraction-limited high quality fiber laser based on 25/400μm fiber

All-fiber High Energy and Peak Power Broadband Yb-doped Fiber Amplifier

All-Fiber High Repetition Rate Short Pulse Generation Around 1030Nm