Abstract:As a very important design principle, the dynamic properties of materials attracted extensive attention in resent years and a bunch of works have been done concerning with the materials deformation behaviors under high strain rates. However, the dynamic behaviors of magnesium alloys are not through understood, especially the rare earth based magnesium alloys. In order to investigate the dynamic and anisotropic behavior under high strain rates deformation of as-extruded Mg-3Zn-1Y magnesium alloy, the split Hopkinson pressure bar (SHPB) apparatus was used to testing the true stress-true strain curves under the high strain rates of 1000, 1500 and 2200 s(-1) of as-extruded Mg-3Zn-1Y magnesium alloy. The OM and SEM were used to analysis the micorstructure evolution and fracture surface morphology of the alloy. The true reason behind the anisotropic phenomenon was revealed based on the deformation mechanism of highly basal-textured magnesium alloy. The results demonstrate that the as-extruded Mg-3Zn-1Y magnesium alloy exhibits pronounced anisotropy during compression according to the loading direction. The anisotropy of the as-extruded Mg-3Zn-1Y magnesium alloy are arised from the variety of the deformation mechanisms. When the loading direction is along extrusion direction, the predominant deformation mode changes from extension twinning at a lower strain to prismatic slip at a higher strain. While compressed along extrusion radial direction (ERD), the predominant deformation mode changes from contraction twinning to a coordination of basal and second order pyramidal slip with the increasing of strain.

The high strain-rate behaviour of three molecular weights of polyethylene examined with a magnesium alloy split-Hopkinson pressure bar

A Novel Methodology for Large Strain under Intermediate Strain Rate Loading

Determination of Dynamic Elastic Modulus of Polymeric Materials Using Vertical Split Hopkinson Pressure Bar

Experimental Measurement of Polyethylene Chain Modulus by Scanning Force Microscopy

Testing of Polymeric Foams at High and Medium Strain Rates

Investigation on Experimental Method of Low-Impedance Materials Using Modified Hopkinson Pressure Bar

Characterizing Multi Mechanical Behaviors for Epoxy-Like Materials under Wide Strain Rate Range

Impact testing of high-density polyethylene structure

A split Hopkinson bar technique for low-impedance materials

Strain-rate effect of polymers and correction methodology in a SHPB test

On loading ceramic-like materials using split Hopkinson pressure bar

A Hopkinson Pressure Bar with PVDF Thin Film for Measuring Dynamic Behavior of Metallic Foams

On Measuring the Dynamic Elastic Modulus for Metallic Materials Using Stress Wave Loading Techniques

Experimental and numerical investigations on the use of polymer Hopkinson pressure bars

A novel Hopkinson tension bar system for testing polymers under intermediate strain rate and large deformation

Anisotropy and Deformation Mechanisms ofAs-Extruded Mg-3Zn-1Y Magnesium AlloyUnder High Strain Rates

A Study of Specimen Thickness Effects in the Impact Tests on Polymers by Numeric Simulations

Study on Dynamic Mechanical Properties of Magnesium Alloy AZ61

The Testing and Behaviour Modelling of Sheet Metals at Strain Rates from 10−4 to 104 S−1

Device and method for investigation of mechanical properties of the materials under high-strain rate tensile load

Simultaneous Multiscale Measurements on Dynamic Deformation of a Magnesium Alloy with Synchrotron X-Ray Imaging and Diffraction