Abstract:In this paper, we present the dynamic response of commercially pure copper subjected to combined tension-torsion loads representative of real case impact scenarios. Experiments were conducted both quasi statically, at a strain rate equal to 10−3 s−1, and dynamically at strain rates in the region between 500 s−1 and 1000 s−1. All high rate experiments were conducted using a novel Split Hopkinson Tension-Torsion Bar instrumented with high-speed photographic equipment. The dynamic combined loading experiments demonstrate the capability of the apparatus to generate longitudinal and torsional stress waves which are synchronised upon loading of the specimen. The presented data show that dynamic equilibrium conditions and nearly steady strain rates were achieved during the experiments. Additionally, the analyses of the loading paths show that nearly proportional strain loading was attained during testing.The measured experimental results illustrate, for the first time, the failure stress locus of the material over a wide range of stress states including pure torsion, shear-dominated combined tension-shear, tension-dominated combined tension-shear and plain tension. The quasi-static and dynamic failure envelopes are herein presented in the normal stress vs shear stress space to motivate the development of accurate and effective constitutive models. To conclude, the Drucker-Prager criterion was employed to approximate the failure loci and to assess the rate sensitivity of the material. A moderate asymmetry of the uniaxial ultimate stresses in tension and compression is predicted both at quasi-static and dynamic strain rates.

Device and method for investigation of mechanical properties of the materials under high-strain rate tensile load

Experimental Technique of High Strain-Rate Tension Based on Hopkinson Bar

Dynamic Testing of Materials with the Rotating Disk Indirect Bar-Bar Tensile Impact Apparatus

On the Development of New Test Techniques to Measure the Tensile Response of Materials at High and Ultra-high Strain Rates

Beyond Hopkinson's bar

An alternative method for the measurement of mechanical properties at intermediate strain rates: a numerical study

Experimental analysis of the multiaxial failure stress locus of commercially pure titanium at low and high rates of strain

A novel Hopkinson tension bar system for testing polymers under intermediate strain rate and large deformation

Material characterization at high strain rate by Hopkinson bar tests and finite element optimization

A split Hopkinson bar technique for low-impedance materials

Challenges related to testing of composite materials at high strain rates using the split Hopkinson bar technique

A Novel Integrated Tension-Compression Design for A Mini Split Hopkinson Bar Apparatus

Material behaviour characterisation using SHPB techniques, tests and simulations

Compressive Split Hopkinson Pressure Bar Apparatus: Part I - Design and Development

Methodological aspects of testing brittle materials using the split Hopkinson bar technique

Hopkinson bar experiments as a method to determine impact properties of brittle and ductile materials

A Review of the Torsional Split Hopkinson Bar

The mechanical response of commercially pure copper under multiaxial loading at low and high strain rates

A new split Hopkinson tensile bar design

A new technique for combined dynamic compression-shear test