Abstract:The article describes the development of a modification of the Kolsky method used for testing brittle materials at splitting. The scheme of the experiment involves the application of a dynamic load along diametrically opposite generatrices of the cylindrical surface of the test specimen. At the same time, it is in a biaxial stressed state and fracture into two halves from the action of tensile stresses. The method is based on the assumption that the material under test behaves elastically under equilibrium deformation of the specimen. This modification is proposed to be used to determine the dynamic Young's modulus and Poisson's ratio. The derivation of relations for calculating the indicated mechanical characteristics based on Hooke's law using experimental possibilities is given. Approbation of the proposed scheme for determining elastic constants was carried out when testing specimens of fireclay brick in the Hopkinson split bar system. The deformation impulses of measuring bars were recorded with the help of tensometry to assess the forces acting on the sample and calculate the stresses arising in its center. Deformations of the central part of the specimen were determined using digital image correlation technology. The obtained graphs of stresses and strains versus time had a different time step using the optical method in combination with tensometry. The arrays of the obtained stress and strain values were reduced to a single and constant time interval up to the moment of specimen failure using linear interpolation to process the experimental data based on the derived formulas. The study made it possible to construct graphs of the dynamic Young's modulus and Poisson's ratio versus time at the initial stage of specimen loading and to determine the average values of these elastic mechanical characteristics.

Methodological aspects of testing brittle materials using the split Hopkinson bar technique

Hopkinson bar experiments as a method to determine impact properties of brittle and ductile materials

Dynamic Behavior of Reactive Powder Concrete in Split Hopkinson Pressure Bar Testing

Compressive Impact Tests of Lightweight Concrete with 155-Mm-diameter Spilt Hopkinson Pressure Bar

A split Hopkinson bar technique for low-impedance materials

Hopkinson Bar Loaded Fracture Experimental Technique: A Critical Review of Dynamic Fracture Toughness Tests

DETERMINATION OF THE DYNAMIC YOUNG'S MODULUS AND POISSON'S RATIO OF BRITTLE MATERIALS

An electromagnetic Hopkinson bar for low wave impedance material and complex stress paths loading tests

Design of an Innovative System for Wave Generation in Direct Tension–Compression Split Hopkinson Bar

A practical note for SHPB test with new algorithms for delimiting pulses

On the use of SHPB techniques to determine the dynamic behavior of materials in the range of small strains

Dynamic shear response of a polymer bonded explosive using a modified Hopkinson bar apparatus

Hopkinson bar pulse smoothing

Challenges related to testing of composite materials at high strain rates using the split Hopkinson bar technique

Dynamic Brazilian Test of Brittle Materials Using the Split Hopkinson Pressure Bar and Digital Image Correlation

Dynamic compressive and splitting tensile tests on mortar using split Hopkinson pressure bar technique

A novel Hopkinson tension bar system for testing polymers under intermediate strain rate and large deformation

Material behaviour characterisation using SHPB techniques, tests and simulations

Experimental and numerical investigations on the use of polymer Hopkinson pressure bars

Design, development, and calibration of split Hopkinson pressure bar system for Dynamic material characterization of concrete

Device and method for investigation of mechanical properties of the materials under high-strain rate tensile load