Abstract:The anisotropic plasticity of sheet metals at high strain rates is a critical factor that can influence the fabrication and service safety of engineering parts under dynamic loading conditions. The characterization of dynamic anisotropic plasticity using conventional testing methods usually suffers from the limitations resulted from the homogeneous deformation state and one-dimensional wave propagation preconditions. In this work, a highly efficient approach is proposed for the simultaneous identification of the anisotropic yielding and hardening constitutive parameters at high strain rates based on the heterogeneous impact test and the virtual fields method. First, the identification framework that combines the selected anisotropic plasticity constitutive models and the principle of virtual work concerning the dynamic kinematics term is introduced. In order to validate the proposed identification algorithm, simulated virtual impact tests were performed to provide reference parameters and unpolluted inertial acceleration/strain/strain rate field data. These data were then processed to extract the target dynamic anisotropic parameters. The results show that using the double-notched impact configuration and the proposed identification algorithm the selected anisotropic yielding and hardening parameters can be reasonably identified from a single impact test, significantly simplifying the testing procedures compared to conventional dynamic testing methods. Also, the effects of different processing parameters and influential factors on the identification accuracy have been investigated. From the sensitivity studies, the preferred ranges of the processing parameters have been determined and the robustness of the proposed method within these verified.

Dynamic Testing of Materials with the Rotating Disk Indirect Bar-Bar Tensile Impact Apparatus

3-D Dynamic Elastic–plastic FEA for Rotating Disk Indirect Bar–bar Tensile Impact Apparatus: Numerical Analysis for the Generation of Mechanically-Filtered Incident Stress Pulses

Development of Structural Testing Equipment for Impact and Complex Loading

Device and method for investigation of mechanical properties of the materials under high-strain rate tensile load

Experimental Technique of High Strain-Rate Tension Based on Hopkinson Bar

A novel Hopkinson tension bar system for testing polymers under intermediate strain rate and large deformation

A Novel Integrated Tension-Compression Design for A Mini Split Hopkinson Bar Apparatus

A complete three-dimensional finite element analysis of the bar-bar tensile impact apparatus

An Optical Method for Evaluating the Mechanical Properties of Wires Under Impact Tensile Load

On the Development of New Test Techniques to Measure the Tensile Response of Materials at High and Ultra-high Strain Rates

A Finite Element Analysis for Using Brazilian Disk in Split Hopkinson Pressure Bar to Investigate Dynamic Fracture Behavior of Brittle Polymer Materials

Optimal Design, Development and Experimental Analysis of a Tension–Torsion Hopkinson Bar for the Understanding of Complex Impact Loading Scenarios

Dynamic split tensile test of Flattened Brazilian Disc of rock with SHPB setup

A Method for Testing Dynamic Tensile Strength and Elastic Modulus of Rock Materials Using SHPB

Dynamic Tensile Testing of Based and Welded Automotive Steel

Development of Tensile Split Hopkinson Pressure Bar Technique for Studying the Dynamic Behaviour of Metals

Impact Friction Test For Friction Materials

An Apparatus for Measuring Mechanical Properties of Microstructures in Tensile Mode

Hopkinson Bar Loaded Fracture Experimental Technique: A Critical Review of Dynamic Fracture Toughness Tests

Achieving synchronous compression-shear loading on SHPB by utilizing mechanical metamaterial

A VFM-based identification method for the dynamic anisotropic plasticity of sheet metals