Abstract:<p>Rock engineering projects at depth are frequently subjected to dynamic loadings under <em>in-situ</em> stress state, and the studies should be conducted to decipher the coupled effect of confining pressure and strain rate on the behaviour of rocks. The triaxial Hopkinson bar system has been applied to investigate the responses of materials to the coupled multiaxial static-dynamic loads. In this study, a three-dimensional (3D) continuum-discrete coupled method is employed to establish a numerical-based triaxial Hopkinson bar system, and the steel bars and a cubic specimen are modelled by continuum zones and bonded-particle material, respectively. Firstly, the detailed numerical modelling is performed to verify some prerequisites and uncertainties in the experiments, including stress wave propagation and attenuation in three directions, dynamic stress equilibrium, boundary effects, interfacial frictions, and controversial methodologies for applying confining pressure, by using the flat-joint model and parallel bond model. Then, both experimental tests and numerical modelling are carried out on sandstone under multiaxial pre-stress conditions (i.e., uniaxial, biaxial and triaxial compression) followed by dynamic loads. The dynamic responses of rock, including stress-strain curves, dynamic strength, energy evolutions, and damage patterns, exhibit confinement dependence, which is in good agreement with experimental observations. Under uniaxial compression, the specimens are broken into fragments by multiple fractures; while under biaxial compression, two symmetrically distributed V-shaped damage zones form near the free surfaces. Under triaxial compression, the degree of damage is substantially reduced, and microcrack localisation zones are initiated from the surface, propagate to the interior and eventually form macroscopic fractures. Moreover, a series of numerical simulations is conducted to investigate the strain rate dependence of sandstone under multiaxial load conditions. Both dynamic strength and peak lateral dynamic stresses increase with increasing strain rate. The increase of dynamic strength and failure strain becomes obvious at high strain rates with the enhancement of lateral confinement.</p>

Optimal Design, Development and Experimental Analysis of a Tension–Torsion Hopkinson Bar for the Understanding of Complex Impact Loading Scenarios

Development of Structural Testing Equipment for Impact and Complex Loading

A novel Hopkinson tension bar system for testing polymers under intermediate strain rate and large deformation

Isogeometric Analysis-Based Design of Post-Tensioned Concrete Beam Towards Construction-Oriented Topology Optimization

Experimental Studies on Concrete Filled Steel Tubes under High Strain Rate Loading

Material characterization at high strain rate by Hopkinson bar tests and finite element optimization

A Review of the Torsional Split Hopkinson Bar

Hopkinson bar experiments as a method to determine impact properties of brittle and ductile materials

Experimental Technique of High Strain-Rate Tension Based on Hopkinson Bar

Beyond Hopkinson's bar

Hopkinson Bar Loaded Fracture Experimental Technique: A Critical Review of Dynamic Fracture Toughness Tests

Dynamic Testing of Materials with the Rotating Disk Indirect Bar-Bar Tensile Impact Apparatus

An electromagnetic Hopkinson bar for low wave impedance material and complex stress paths loading tests

The use of the Hopkinson bar to validate constitutive relations at high rates of strain

Design of an Innovative System for Wave Generation in Direct Tension–Compression Split Hopkinson Bar

3-D Dynamic Elastic–plastic FEA for Rotating Disk Indirect Bar–bar Tensile Impact Apparatus: Numerical Analysis for the Generation of Mechanically-Filtered Incident Stress Pulses

A Novel Integrated Tension-Compression Design for A Mini Split Hopkinson Bar Apparatus

On the Development of New Test Techniques to Measure the Tensile Response of Materials at High and Ultra-high Strain Rates

Experimental analysis of the multiaxial failure stress locus of commercially pure titanium at low and high rates of strain

3D continuum-discrete coupled modelling of triaxial Hopkinson bar tests on rock under multiaxial static-dynamic loads