Abstract:Since the split-Hopkinson pressure bar (SHPB) test technology was proposed, it has played an important role in the study of dynamic mechanical properties of materials under the impact of dynamic load. It is a major test technology for the study of dynamic mechanical properties of materials. The expansion of the range of materials studied has also posed a challenge to the SHPB test technique, requiring some improvements to the conventional SHPB test apparatus and analysis methods to meet the test conditions and ensure the accuracy of its results. Based on a systematic review of the development of the SHPB test technique and the test principles, the main factors that influence the test's ability to meet the two basic assumptions at this stage are analyzed, and the ways to handle them are summarized. The stress wave dispersion phenomenon caused by the transverse inertia effect of the pressure bar means that the test no longer satisfies the one-dimensional stress wave assumption, while the pulse-shaping technique effectively reduces the wave dispersion phenomenon and also has the effect of achieving constant strain rate loading and promoting the dynamic stress equilibrium of the specimen. Impedance matching between the pressure bar and specimen effectively solves the problem of the test's difficulty because the transmitted signal is weak, and the assumption that the stress/strain is uniformly distributed along the length of the specimen is not satisfied when studying low-wave impedance material with the conventional SHPB test device. The appropriate pressure bar material can be selected according to the value of the wave impedance of the test material. According to the wave impedance values of different materials, the corresponding suggestions for the selection of pressure bar materials are given. Moreover, a new pressure bar material (modified gypsum) for materials with very-low-wave impedance is proposed. Finally, for some materials (foamed concrete, aluminum honeycomb, porous titanium, etc.) that cannot meet the two basic assumptions of the test, the Lagrangian analysis method can be combined with SHPB test technology application. Based on the analysis and calculation of the energy conservation equation, the dynamic constitutive relationship of the materials can be obtained without assuming the constitutive relationship of the experimental materials.

Strain-rate effect of polymers and correction methodology in a SHPB test

Experimental and numerical investigations on the use of polymer Hopkinson pressure bars

High-strain Rate Compressive Behavior of CFRP Confined Concrete: Large Diameter SHPB Tests

Numerical Investigation on the Necessity of a Constant Strain Rate Condition According to Material’s Dynamic Response Behavior in the SHPB Test

On the use of SHPB techniques to determine the dynamic behavior of materials in the range of small strains

Material behaviour characterisation using SHPB techniques, tests and simulations

A theoretical analysis about the influence of interfacial friction in SHPB tests

Strain rate effect of concrete based on split Hopkinson pressure bar (SHPB) test

Numerical and Theoretical Analysis of the Inertia Effects and Interfacial Friction in SHPB Test Systems

Review of SHPB Dynamic Load Impact Test Characteristics and Energy Analysis Methods

Correlation between the accuracy of a SHPB test and the stress uniformity based on numerical experiments

Evolution of specimen strain rate in split Hopkinson bar test

Effect of Strain Rate on the Compressive Behavior of Polyurethane Bonding

Tension testing of polycarbonate at high strain rates

A practical note for SHPB test with new algorithms for delimiting pulses

Design, development, and calibration of split Hopkinson pressure bar system for Dynamic material characterization of concrete

A modified method for estimating the stress state of granular materials in the passive confined pressure SHPB tests

The high strain-rate behaviour of three molecular weights of polyethylene examined with a magnesium alloy split-Hopkinson pressure bar

Material characterization at high strain rate by Hopkinson bar tests and finite element optimization

Dynamic Response of Rock-like Materials Based on SHPB Pulse Waveform Characteristics

Pulse Design of Constant Strain Rate Loading in SHPB Based on Pulse Shaping Technique