Abstract:We have attempted to apply the computer-based finite element analysis (FEA) method to accurately measure the mechanical properties (e.g., hardness and elasticity) of a soft material by an indentation test. First, an axisymmetric model has been developed using commercially available FEA code ANSYS. The FEA model consisted of a thin Al-film resting on Si-substrate. A spherical indenter has been used to indent the Al-film, which traveled a predefined depth during the loading and unloading cycles. First, numerical simulations were conducted to get the force vs. displacement plot, which was later used to determine the modulus of elasticity and hardness of Al-film. The effects of substrate modulus and indentation depth were thoroughly investigated to determine the modulus and hardness of Al-film. The effect of friction, considered at the interface of indenter and Al-film, was found to offer minimum impact for relatively small indentation depth. The induced force on the Al-film by the indenter has been found to be higher with increasing indentation depth when friction was considered. However the contact stiffness, represented by the slope of the unloading curve, has been found almost the same with and without considering friction. The variation of substrate modulus has been found to be ineffective to capture the Al-film modulus for relatively small indentation depth. However for higher indentation depth, the substrate modulus has been found to offer profound effect to capture the film modulus. The hardness of the Al-film has also been found to be relatively unaffected with variation of substrate modulus. However, the hardness of the Al-film has been found to be higher with friction for relatively high indentation depth. Results obtained from this preliminary research are important to continue further investigation and to characterize the mechanical properties of other soft-materials, e.g., biofilms to minimize its detrimental effects and utilize its favorable aspects in industrial and biomedical applications.

Spherical Indentation on an Elastic Coating/Substrate System: Determining Substrate Modulus

Measuring elastoplastic properties of thin films on an elastic substrate using sharp indentation

Surface Effects on the Spherical Indentation of Biological Film/substrate Structures

Effects of surface energy and substrate on modulus determination of biological films by conical indentation

On the Effect of Substrate Properties on the Indentation Behaviour of Coated Systems

Measuring the Elastic Modulus of Soft Thin Films on Substrates

Surface Effects on Cylindrical Indentation of a Soft Layer on a Rigid Substrate

Surface Effects on the Indentation of a Soft Layer on a Rigid Substrate with an Elliptical Cylinder Indenter

Indentation of pre-deformed compressible soft electroactive layer on substrate

Identifying the Viscoelastic Properties of Soft Matter from the Indentation Response of a Hard Film-Soft Substrate System

Spherical indentation on biological films with surface energy

A Method to Determine the Constitutive Parameters of Hyperelastic Films Based on Spherical Indentation

New sharp indentation method of measuring the elastic–plastic properties of compliant and soft materials using the substrate effect

Exploration of the Origin of Substrate Effects and Elastic Strain Properties During Thin Film Nanoindentation

Correction of Substrate-Induced Thin-Film Modulus Deviations in Nanoindentation Measurements

An Indentation Method to Determine the Constitutive Parameters of Hyperelastic Films under Large Deformation: Theoretical Model, Experiments and Simulations

Use of Scaling Functions to Determine Mechanical Properties of Thin Coatings from Microindentation Tests

Nano-Indentation for Characterizing Mechanical Properties of Soft Materials

Spherical Indentation into Elastoplastic Materials: Indentation-response Based Definitions of the Representative Strain

Effects of the Substrate on the Determination of SEBS Thin Film Mechanical Properties by Nanoindentation

Mechanics of Indentation for Piezoelectric Thin Films on Elastic Substrate