Abstract:We have attempted to apply the computer-based finite element analysis (FEA) method to accurately measure the mechanical properties (e.g., hardness and elasticity) of a soft material by an indentation test. First, an axisymmetric model has been developed using commercially available FEA code ANSYS. The FEA model consisted of a thin Al-film resting on Si-substrate. A spherical indenter has been used to indent the Al-film, which traveled a predefined depth during the loading and unloading cycles. First, numerical simulations were conducted to get the force vs. displacement plot, which was later used to determine the modulus of elasticity and hardness of Al-film. The effects of substrate modulus and indentation depth were thoroughly investigated to determine the modulus and hardness of Al-film. The effect of friction, considered at the interface of indenter and Al-film, was found to offer minimum impact for relatively small indentation depth. The induced force on the Al-film by the indenter has been found to be higher with increasing indentation depth when friction was considered. However the contact stiffness, represented by the slope of the unloading curve, has been found almost the same with and without considering friction. The variation of substrate modulus has been found to be ineffective to capture the Al-film modulus for relatively small indentation depth. However for higher indentation depth, the substrate modulus has been found to offer profound effect to capture the film modulus. The hardness of the Al-film has also been found to be relatively unaffected with variation of substrate modulus. However, the hardness of the Al-film has been found to be higher with friction for relatively high indentation depth. Results obtained from this preliminary research are important to continue further investigation and to characterize the mechanical properties of other soft-materials, e.g., biofilms to minimize its detrimental effects and utilize its favorable aspects in industrial and biomedical applications.

Spherical indentation on biological films with surface energy

Effects of surface energy and substrate on modulus determination of biological films by conical indentation

Measuring elastoplastic properties of thin films on an elastic substrate using sharp indentation

Video Enhanced Depth-Sensing Indentation Technique for Characterizing Mechanical Behaviour of Biomaterials

In Situ Nanoindentation Mechanical Property of Films by Atomic Force Microscope

Nano-Indentation for Characterizing Mechanical Properties of Soft Materials

Surface Effects on the Indentation of a Soft Layer on a Rigid Substrate with an Elliptical Cylinder Indenter

Spherical Indentation into Elastoplastic Materials: Indentation-response Based Definitions of the Representative Strain

Identifying the Viscoelastic Properties of Soft Matter from the Indentation Response of a Hard Film-Soft Substrate System

An indentation-based approach to determine the elastic constants of soft anisotropic tissues

Finite indentation of highly curved elastic shells

Indentation of A Square Elastomeric Thin Film by A Flat-Ended Cylindrical Punch in the Presence of Long-Range Intersurface Forces

In Situ Elasticity and Adhesion Measurement of Biomembrane by a Video Enhanced Depth-Sensing Indentation Technique

Spherical Indentation Method for Determining the Constitutive Parameters of Hyperelastic Soft Materials

Square indentation on a soft elastomer layer with finite thickness

Surface Effects on Cylindrical Indentation of a Soft Layer on a Rigid Substrate

Macro-indentation testing of soft biological materials and assessment of hyper-elastic material models from inverse finite element analysis

Elastic Contact Versus Indentation Modeling of Multilayered Materials

Effect of the curvature for the indented solid with curved surface using flat punch indentation

Modelling indentation of human lower-limb soft tissue: simulation parameters and their effects

Identification of plastic properties through spherical indentation