Abstract:Plasma-wall interaction (PWI) is a critical concern in tokamaks because of its significant impact on the lifetimes of plasma-facing materials (PFMs), fuel retention, and plasma performance. In 2020, the Experimental Advanced Superconducting Tokamak (EAST) PFMs were upgraded to predominantly metallic walls. Following the 2021 experimental campaign, the deposition distribution and fuel retention on the surfaces of the PFMs along both the poloidal and toroidal directions were analyzed. The poloidal tests commenced at the high-field side (HFS), proceeded to the lower divertor, then to the low-field side (LFS), and finally to the upper divertor. The toroidal tests were performed at the midplane of the HFS, beginning from port A and ending at port P. The distributions of the deposits in the poloidal and toroidal directions were clearly asymmetrical. Mo and Fe particles sputtered from the first wall and inner stainless steel (SS) components were prone to deposition in the lower divertor region, as evidenced by the fact that the elemental content in the far-SOL region of the inner divertor exhibited Mo and Fe peaks, as did both the near- and far-SOL regions of the outer divertor. In addition, quick re-deposition of W and Fe was observed, as demonstrated by the fact that their contents near the erosion sources were higher than those farther away along the toroidal first wall on the HFS. This tendency was stronger for W than for Fe. Further analysis indicated that the deposits consisted of Li, C, O, W, Mo, Fe, Cu, and Ni. The Li and Fe contents were much higher than those of other metal impurities, with peak values of 8.17 μg/mm 2 and 7.78 μg/mm 2 , respectively. The Li content decreased along the HFS first wall from 8.17 μg/mm 2 at P-2 to 1.82 μg/mm 2 at P-22, and then increased to 2.72 μg/mm 2 at P-32 in the divertor, while the Fe content was higher around the top side and the midplane of the HFS. The deposited Li originated from routine wall conditioning and existed primarily in the form of Li 2 CO 3 . Additionally, other metal impurities deposited on the Li 2 CO 3 surfaces exhibited various irregular shapes, often appearing as aggregated and recrystallized small particles. Furthermore, significant deuterium (D) retention on the order of 10 21 atoms/m 2 was measured on all the analyzed SiC-coated graphite tiles on the HFS. The D content at location P-10 at the midplane was the highest along the poloidal direction of the HFS because it was directly facing the NBI beam.

Hydrogen content in divertor baffle tiles in Wendelstein 7-X

Overview of Hl-2a Experiment Results

Plasma-wall interaction studies in W7-X: main results from the recent divertor operations

Understanding baffle overloads observed in high-mirror configuration on Wendelstein 7-X

Stable heat and particle flux detachment with efficient particle exhaust in the island divertor of Wendelstein 7-X

An extensive analysis of SOL properties in high-δ plasmas in ASDEX Upgrade

Surface Diversifying and Deuterium Retention Characteristics of Doped Graphite with SiC Coating Exposed to Plasma Discharges in EAST Tokamak

Divertor enrichment of recycling impurity species (He, N 2 , Ne, Ar, Kr) in ASDEX Upgrade H-modes

Physics basis for the first ITER tungsten divertor

Surface Modifications of W Divertor Components for East During Exposure to High Heat Loads with He

Influence of hydrogen content in tokamak scrape-off-layer on performance of lithium divertor

Spatially dependent cluster dynamics model of He plasma surface interaction in tungsten for fusion relevant conditions

Post-mortem analysis of material deposition and fuel retention on the plasma-facing materials after the 2021 campaign in EAST

Improvement in the simulation tools for heat distribution predictions and control of baffle and middle divertor loads in Wendelstein 7-X

Analysis of the neutral fluxes in the divertor region of Wendelstein 7-X under attached and detached conditions using EMC3-EIRENE

LIA-QMS method for the quantity analysis of the hydrogen isotopes retention in first-wall components of Globus-M2 tokamak

Overview of tritium retention in divertor tiles and dust particles from the JET tokamak with the ITER-LIKE WALL

Influence of Surface Melting on the Deuterium Retention in Pure and Lanthanum Oxide Doped Tungsten

Improved erosion estimates for the STEP divertor

Survey of tungsten gross erosion from main plasma facing components in WEST during a L-mode high fluence campaign

Bubble Formation in ITER-Grade Tungsten after Exposure to Stationary D/He Plasma and ELM-like Thermal Shocks