Abstract:The microstructure and electrical–optical properties of Al-doped ZnO (AZO) films have been studied as a function of H2 flux in the magnetron sputtering process at 150 °C and postannealing temperature in vacuum. As H2 flux increases in the sputtering gas, the AZO films deposited have a (002) preferred orientation rather than the mixed (100) and (002) orientations, the grain size shows a tendency to first increase then decrease, and (002) diffraction peak position is inclined to shift to higher angles first then to lower angles. The resistivity of the films first decreases then increases with H2 flux, and the lowest resistivity of 4.02 × 10−4 Ω cm is obtained at a H2 flux of 10 sccm. The average transmittance in the visible region shows little dependence on H2 flux. As a whole, the AZO films with higher values of figure of merit are obtained when the H2 flux is in the range of 6–12 sccm. The AZO films deposited in Ar and Ar + H2 exhibit different annealing behaviors. For the AZO film deposited in Ar, the grain size gradually increases, the stresses are relaxed, the resistivity first decreases then increases, and the average transmittance in the visible region is unchanged initially then somewhat decreased as annealing temperature is increased. The optimum annealing temperature for improving properties of AZO films deposited in Ar is 300 °C. For the AZO films deposited in Ar + H2, annealing does not significantly change the microstructure but increases the resistivity of the films; the average transmittance in the visible region remains unchanged initially but greatly reduced with further increase in annealing temperature. The carrier transport in the as-deposited and annealed films appears to be controlled by a mechanism of grain boundary scattering, and the value of Eg increases with the increase in carrier concentration due to Burstein–Moss effect.

Effect of Ar-flow variation on physical properties of Al-ZnO films prepared by RF sputtering used for solar cell application

Influence of Argon Flow on Optic-electronic Performance of Aluminum Doped Zinc Oxide Thin Films

Deposition and Characterization of AZO Thin Films on Flexible Glass Substrates Using DC Magnetron Sputtering Technique

Influence of O_2/Ar Flow Ratio on Microstructures and Photoluminescence of ZnO Films

Effects of Hydrogen Flux on Aluminum Doped Zinc Thin Films by Pulsed Magnetron Sputtering

Sputtered AZO Thin Films for TCO and Back Reflector Applications in Improving the Efficiency of Thin Film a-Si:H Solar Cells

Thickness Study of AZO Films by RF Sputtering in Ar + H2 Atmosphere at Room Temperature

Effects of deposition power and pressure on the crystallinity of Al-doped ZnO thin films at glass substrates by low temperature RF magnetron sputtering

Highly Surface-Textured ZnO:Al Films Fabricated by Controlling the Nucleation and Growth Separately for Solar Cell Applications

Structural and Optoelectronic Properties of AZO Thin Films Prepared by RF Magnetron Sputtering at Room Temperature

The fabrication and application of ZnO:Al thin films in low-frequency inductively coupled plasma fabricated silicon solar cell

Effects of DC Sputtering Power on the Properties of AZO Films Deposited at Room Temperature for CIGS Photovoltaics

Preparation and characterization of high-transmittance AZO films using RF magnetron sputtering at room temperature

Room Temperature Sputtered Aluminum-Doped ZnO Thin Film Transparent Electrode for Application in Solar Cells and for Low-Band-Gap Optoelectronic Devices

Effects of O_2/Ar Ratio at Rated Pressure on Conductivity of Thin ZnO:Al Films

Characteristics of Al-doped ZnO Thin Films Prepared in Ar + H2 Atmosphere and Their Vacuum Annealing Behavior

Impact of aluminium doping in magnesium-doped zinc oxide thin films by sputtering for photovoltaic applications

The effects of RF power on crystal structure and electrical properties of aluminum-doped zinc oxide films prepared by RF magnetron sputtering technique

Effects of sputtering power on the properties of Al-doped ZnO films deposited on amorphous silicon films substrate

Tailoring the Morphology, Optical and Electrical Properties of DC-sputtered ZnO:Al Films by Post Thermal and Plasma Treatments

Elucidating the microstructural and optoelectronic properties evolution of sputtered Al-doped MZO thin films