Abstract:High average power, all-fiber integrated, broadband supercontinuum (SC) sources are demonstrated. Architecture for SC generation using amplified picosecond/nanosecond laser diode (LD) pulses followed by modulation instability (MI) induced pulse breakup is presented and used to demonstrate SC sources from the mid-IR to the visible wavelengths. In addition to the simplicity in implementation, this architecture allows scaling up of the SC average power by increasing the pulse repetition rate and the corresponding pump power, while keeping the peak power, and, hence, the spectral extent approximately constant. Using this process, we demonstrate >10W in a mid-IR SC extending from ∼0.8 to 4μm, >5W in a near IR SC extending from ∼0.8 to 2.8μm, and >0.7W in a visible SC extending from ∼0.45 to 1.2μm. SC modulation capability is also demonstrated in a mid-IR SC laser with ∼3.9W in an SC extending from ∼0.8 to 4.3μm. The entire system and SC output in this case is modulated by a 500Hz square wave at 50% duty cycle without any external chopping or modulation. We also explore the use of thulium doped fiber amplifier (TDFA) stages for mid-IR SC generation. In addition to the higher pump to signal conversion efficiency demonstrated in TDFAs compared to erbium/ytterbium doped fiber amplifier (EYFA), the shifting of the SC pump from ∼1.5 to ∼2μm is pursued with an attempt to generate a longer extending SC into the mid-IR. We demonstrate ∼2.5 times higher optical conversion efficiency from pump to SC generation in wavelengths beyond 3.8μm in the TDFA versus the EYFA based SC systems. The TDFA SC spectrum extends from ∼1.9 to 4.5μm with ∼2.6W at 50% modulation with a 250 Hz square wave. A variety of applications in defense, health care and metrology are also demonstrated using the SC laser systems presented in this paper.

High-Power Flat Supercontinuum Generation by Using UHNA7 Fiber With Spectrum of 1.77-3.31 μm

Ultra-flat and high-efficient mid-infrared supercontinuum generation in indium fluoride fiber

Supercontinuum generation based on nanofiber

All-fiber ultra-flat supercontinuum source covering 1.85–3.57 μm based on germania-core fiber

High power all fiber mid-IR supercontinuum generation in a ZBLAN fiber pumped by a 2 μm MOPA system

714 W all-fiber supercontinuum generation from an ytterbium-doped fiber amplifier

Compact and efficient high-power mid-infrared supercontinuum fiber laser source based on a noise-like pulse and germania fiber

Half Mj Supercontinuum Generation in A Telecommunication Multimode Fiber by A Q-Switched Tm, Ho:Yvo4 Laser

2 Mu M Femtosecond Fiber Laser Source And Its Application For Mid-Ir Supercontinuum Generation

Modulation instability initiated high power all-fiber supercontinuum lasers and their applications

All-Fiber Wideband Supercontinuum Generation in Short Hybrid Highly Nonlinear Fibers With a Femtosecond Erbium-Doped Fiber Laser

An ultra-flat, low-noise and linearly polarized fiber supercontinuum source covering 670 nm-1390 nm

Combined Supercontinuum Source with >200 W Power Using a 3 × 1 Broadband Fiber Power Combiner.

Ultra-flat supercontinuum generated from high-power, picosecond telecommunication fiber laser source

All Fiber Structured Supercontinuum Source Based on Graded-Index Multimode Fiber

Broadband supercontinuum generation in a telecommunication fibre pumped by a nanosecond Tm, Ho:YVO4 laser

Deep-UV to mid-IR supercontinuum generation driven by mid-IR ultrashort pulses in a gas-filled fiber

40 W of supercontinuum generated by a self-pulsed pump-sharing oscillator-amplifier

High-power Optical Continuous-Wave Waveguiding in a Silica Micro/nanofiber

Numerical research on mid-infrared supercontinuum generation in Ge11.5As24Se64.5 few-mode photonic crystal fibers

Proposal of On-Chip Ultrabroad Supercontinuum Generation Ranging from Visible to Mid-Infrared Spectrum