Abstract:This paper introduces a compact picosecond laser system using tapered double cladding fiber-single crystal fiber hybrid amplification technology for the first time. By modifying the Ginzburg-Landau equation, we established a simulation model and designed a passive mode-locked picosecond oscillator based on a semiconductor saturable absorber mirror. The oscillator outputs laser with a pulse width of 7.75 ps, a center wavelength of 1030.55 nm, and a spectrum width of 0.58 nm. The seed laser is stretched and amplified by the all-fiber front stage, and then injected into the tapered double cladding fiber-single crystal fiber hybrid amplifier. The laser power is amplified from 820 mw to 103.1 W, obtaining a gain of 21 dB. We used zero-phonon line pumping technology in single crystal fiber amplifier to reduce the thermal effects caused by quantum loss, thereby increasing the length of the crystal and increasing the power loading capacity. We designed a single crystal fiber amplification module using Yb:YAG with 60 mm long, 1 mm diameter and a 1 at.% doping rate for the first time. Finally a hundred-watt level picosecond laser output with a repetition frequency of 26.33 MHz, an average power of 103.1 W, a pulse width of 244.72 ps, a spectrum width of 1.16 nm, and a beam quality of M2 x = 1.368 and M2 y = 1.511 was obtained. To the best of our knowledge, this is the highest picosecond laser output power for an all-fiber front-stage combined with a single-stage single crystal fiber amplifier.

Ultra-flat supercontinuum generated from high-power, picosecond telecommunication fiber laser source

Supercontinuum generation based on nanofiber

An ultra-flat, low-noise and linearly polarized fiber supercontinuum source covering 670 nm-1390 nm

Broadband supercontinuum generation in a telecommunication fibre pumped by a nanosecond Tm, Ho:YVO4 laser

All Fiberized Supercontinuum Laser Source Based on “figure of Eight” Cavity Modelocked Yb Fiber Laser

Half Mj Supercontinuum Generation in A Telecommunication Multimode Fiber by A Q-Switched Tm, Ho:Yvo4 Laser

High Power All-Fiber Supercontinuum System Based on Graded-Index Multimode Fibers

200 nm supercontinuum generated by subpicosecond optical pulses and its evolution process observation

2 Mu M Femtosecond Fiber Laser Source And Its Application For Mid-Ir Supercontinuum Generation

Experimental and Numerical Study of Supercontinuum Generation in Photonic Crystal Fiber

Visible Supercontinuum Generation With Sub-Nanosecond 532-nm Pulses in All-Solid Photonic Bandgap Fiber

714 W all-fiber supercontinuum generation from an ytterbium-doped fiber amplifier

Generation of Octave-Spanning Super-Continuum in Tapered Single Mode Fibre Pumped by Femtosecond Yb:YCOB Laser

Compact hundred-watt level picosecond laser system based on tapered double cladding fiber-single crystal fiber hybrid amplifier

Broadband Supercontinuum Generation in PCF, HNLF and ZBLAN Fiber with a Carbon-Nanotube-based Passively Mode-locked Erbium-doped Fiber Laser

Numerical investigation of a wideband supercontinuum source based on a large-mode-area photonic crystal fiber pumped at 1.3 μm

Near-infrared supercontinuum generation in an all-normal dispersion MOPA configuration above one hundred watts

Femtosecond 5-W Yb:KGW Slab Laser Oscillator Pumped by a Single Broad-Area Diode and Its Application As Supercontinuum Source

All Fiber Structured Supercontinuum Source Based on Graded-Index Multimode Fiber

Ultra-broad Band Signal Amplification Using Supercontinuum Generation

Supercontinuum Generation in Photonic Crystal Fiber and Tapered Single-Mode Fiber