Abstract:Large-mode-area photonic crystal fiber is used to generate high power, high beam quality supercontinuum. Propagation and supercontinuum generation process of laser pulse in large-mode-area (LMA) photonic crystal fiber (PCF) is simulated by solving the general nonlinear Schrödinger equation (GNLSE) using the split-step Fourier method. Effects of the pump pulse parameters (peak power and chirp) and the length of photonic crystal fiber used on supercontinuum generation are particularly estimated. Nonlinear spectral broadening mechanism of laser pulse in large-mode-area photonic crystal fiber is discussed. The results show that the process of supercontinuum generation can be divided into three stages: initial broadening, dramatic broadening and saturation broadening. The spectrum width and efficiency can be achieved by the optimized length of LMA PCF to insure output of the generated supercontinuum at the dramatic broadening stage. The pump peak power and chirp have important impact on supercontinuum generation. When a small peak power pump is input, the spectrum broadens symmetrically. When the pump peak power increases, it brings little changes with the shorter wavelength component but broader of the longer wavelength component. The time-domain shape of the pulse exhibits concussion modulation as the effect of pulse breakup. When the pump chirp is positive, little influence is shown, except a shift of longer wavelength power by increasing the chirp. But the full width of the supercontinuum has little changes. While the pump chirp is negative and satisfy certain condition, the nonlinear is enhanced to facilitate the supercontinuum generation.

Visible Supercontinuum Generation With Sub-Nanosecond 532-nm Pulses in All-Solid Photonic Bandgap Fiber

Visible Supercontinuum Generation in All-Solid Photonic Bandgap Fiber

Supercontinuum Generation in Submicrometer Diameter Silica Fibers

Supercontinuum generation based on nanofiber

Two octave supercontinuum generation in a non-silica graded-index multimode fiber

Simultaneous Generation of Ultrabroadband Noise-Like Pulses and Intracavity Third Harmonic at 2 Μm

Supercontinuum Generation in Photonic Crystal Fiber and Tapered Single-Mode Fiber

Experimental and Numerical Study of Supercontinuum Generation in Photonic Crystal Fiber

30 W all-fiber supercontinuum generation via graded-index multimode fiber pumped by picoseconds laser pulse

On-Chip Supercontinuum Generation Pumped by Short Wavelength Fiber Lasers

Ultra-flat supercontinuum generated from high-power, picosecond telecommunication fiber laser source

Broadband flat supercontinuum generated by chalcogenide double-clad step-index fiber with special dispersion

Near-infrared supercontinuum generation in an all-normal dispersion MOPA configuration above one hundred watts

[Study on the Supercontinuum Generation with Femtosecond Pulse in Photonic Crystal Fiber].

High Power All-Fiber Supercontinuum System Based on Graded-Index Multimode Fibers

Broadband Supercontinuum Generation in PCF, HNLF and ZBLAN Fiber with a Carbon-Nanotube-based Passively Mode-locked Erbium-doped Fiber Laser

74 Nm, 2.5 GHz Supercontinuum Generation in a Dispersion-Shifted Fiber

Supercontinuum generation and control from large-mode-area photonic crystal fiber

All-fiber mid-infrared supercontinuum generation pumped by ultra-low repetition rate noise-like pulse mode-locked fiber laser

Half Mj Supercontinuum Generation in A Telecommunication Multimode Fiber by A Q-Switched Tm, Ho:Yvo4 Laser

Numerical investigation of a wideband supercontinuum source based on a large-mode-area photonic crystal fiber pumped at 1.3 μm