Abstract:Frequency combs with mode spacing in the range of 10 to 20 gigahertz (GHz) are critical for increasingly important applications such as astronomical spectrograph calibration, high-speed dual-comb spectroscopy, and low-noise microwave generation. While electro-optic modulators and microresonators can provide narrowband comb sources at this repetition rate, a significant remaining challenge is a means to produce pulses with sufficient peak power to initiate nonlinear supercontinuum generation spanning hundreds of terahertz (THz) as required for self-referencing in these applications. Here, we provide a simple, robust, and universal solution to this problem using off-the-shelf polarization-maintaining (PM) amplification and nonlinear fiber components. This fiber-integrated approach for nonlinear temporal compression and supercontinuum generation is demonstrated with a resonant electro-optic frequency comb at 1550 nm. We show how to readily achieve pulses shorter than 60 fs at a repetition rate of 20 GHz and with peak powers in excess of 2 kW. The same technique can be applied to picosecond pulses at 10 GHz to demonstrate temporal compression by a factor of 9x yielding 50 fs pulses with peak power of 5.5 kW. These compressed pulses enable flat supercontinuum generation spanning more than 600 nm after propagation through multi-segment dispersion-tailored anomalous-dispersion highly nonlinear fiber (HNLF) or tantala waveguides. The same 10 GHz source can readily achieve an octave-spanning spectrum for self-referencing in dispersion-engineered silicon nitride waveguides. This simple all-fiber approach to nonlinear spectral broadening fills a critical gap for transforming any narrowband 10 to 20 GHz frequency comb into a broadband spectrum for a wide range of applications that benefit from the high pulse rate and require access to the individual comb modes.

Combined Supercontinuum Source with >200 W Power Using a 3 × 1 Broadband Fiber Power Combiner.

Novel Millimeter-Wave Power Combining Utilizing Wafer Level Packaging Technology

714 W all-fiber supercontinuum generation from an ytterbium-doped fiber amplifier

High power all fiber mid-IR supercontinuum generation in a ZBLAN fiber pumped by a 2 μm MOPA system

40 W of supercontinuum generated by a self-pulsed pump-sharing oscillator-amplifier

All Fiber Structured Supercontinuum Source Based on Graded-Index Multimode Fiber

High Power All-Fiber Supercontinuum System Based on Graded-Index Multimode Fibers

A Compact Broadband Power Combiner for High-Power, Continuous-Wave Applications

Near-infrared supercontinuum generation in an all-normal dispersion MOPA configuration above one hundred watts

Novel 3 × 1 signal combiner with high-power fiber laser output of high beam quality

High-power all-fiber superfluorescent source with fused angle-polished side-pumping configuration.

End-pump silica-fluoride fiber combiner utilizing tapering and assembling technique for mid-infrared laser systems

Kilowatt-level supercontinuum generation employing a homemade taper-shaped ytterbium-doped fiber amplifier

Half Mj Supercontinuum Generation in A Telecommunication Multimode Fiber by A Q-Switched Tm, Ho:Yvo4 Laser

High-robustness good-beam-quality 3×1 signal combiner device for 10-kW all-fiber laser combining applications

High-Power Flat Supercontinuum Generation by Using UHNA7 Fiber With Spectrum of 1.77-3.31 μm

20 GHz fiber-integrated femtosecond pulse and supercontinuum generation with a resonant electro-optic frequency comb

Over 4000 Nm Bandwidth of Mid-Ir Supercontinuum Generation in Sub-Centimeter Segments of Highly Nonlinear Tellurite Pcfs

Modulation instability initiated high power all-fiber supercontinuum lasers and their applications

Combination of highly nonlinear fiber, an optical bandpass filter, and a Fabry-Perot filter to improve the signal-to-noise ratio of a supercontinuum continuous-wave optical source.

Design and fabrication of >20 KW 5 × 1 pump combiner with high efficiency