Abstract:High average power, all-fiber integrated, broadband supercontinuum (SC) sources are demonstrated. Architecture for SC generation using amplified picosecond/nanosecond laser diode (LD) pulses followed by modulation instability (MI) induced pulse breakup is presented and used to demonstrate SC sources from the mid-IR to the visible wavelengths. In addition to the simplicity in implementation, this architecture allows scaling up of the SC average power by increasing the pulse repetition rate and the corresponding pump power, while keeping the peak power, and, hence, the spectral extent approximately constant. Using this process, we demonstrate >10W in a mid-IR SC extending from ∼0.8 to 4μm, >5W in a near IR SC extending from ∼0.8 to 2.8μm, and >0.7W in a visible SC extending from ∼0.45 to 1.2μm. SC modulation capability is also demonstrated in a mid-IR SC laser with ∼3.9W in an SC extending from ∼0.8 to 4.3μm. The entire system and SC output in this case is modulated by a 500Hz square wave at 50% duty cycle without any external chopping or modulation. We also explore the use of thulium doped fiber amplifier (TDFA) stages for mid-IR SC generation. In addition to the higher pump to signal conversion efficiency demonstrated in TDFAs compared to erbium/ytterbium doped fiber amplifier (EYFA), the shifting of the SC pump from ∼1.5 to ∼2μm is pursued with an attempt to generate a longer extending SC into the mid-IR. We demonstrate ∼2.5 times higher optical conversion efficiency from pump to SC generation in wavelengths beyond 3.8μm in the TDFA versus the EYFA based SC systems. The TDFA SC spectrum extends from ∼1.9 to 4.5μm with ∼2.6W at 50% modulation with a 250 Hz square wave. A variety of applications in defense, health care and metrology are also demonstrated using the SC laser systems presented in this paper.

40 W of supercontinuum generated by a self-pulsed pump-sharing oscillator-amplifier

714 W all-fiber supercontinuum generation from an ytterbium-doped fiber amplifier

Supercontinuum generation based on nanofiber

All Fiber Structured Supercontinuum Source Based on Graded-Index Multimode Fiber

Modulation instability initiated high power all-fiber supercontinuum lasers and their applications

Broadband supercontinuum generation in a telecommunication fibre pumped by a nanosecond Tm, Ho:YVO4 laser

High Power, Continuous-wave Supercontinuum Generation in Highly Nonlinear Fibers Pumped with High Order, Cascaded Raman Fiber Amplifiers

Femtosecond 5-W Yb:KGW Slab Laser Oscillator Pumped by a Single Broad-Area Diode and Its Application As Supercontinuum Source

An ultra-flat, low-noise and linearly polarized fiber supercontinuum source covering 670 nm-1390 nm

Half Mj Supercontinuum Generation in A Telecommunication Multimode Fiber by A Q-Switched Tm, Ho:Yvo4 Laser

Generation of Octave-Spanning Super-Continuum in Tapered Single Mode Fibre Pumped by Femtosecond Yb:YCOB Laser

74 Nm, 2.5 GHz Supercontinuum Generation in a Dispersion-Shifted Fiber

High Power All-Fiber Supercontinuum System Based on Graded-Index Multimode Fibers

200 nm supercontinuum generated by subpicosecond optical pulses and its evolution process observation

Kilowatt-level supercontinuum generation employing a homemade taper-shaped ytterbium-doped fiber amplifier

Kilowatt-Level Supercontinuum Generation in Random Raman Fiber Laser Oscillator With Full-Open Cavity

30 W all-fiber supercontinuum generation via graded-index multimode fiber pumped by picoseconds laser pulse

All-Fiber Wideband Supercontinuum Generation in Short Hybrid Highly Nonlinear Fibers With a Femtosecond Erbium-Doped Fiber Laser

High power all fiber mid-IR supercontinuum generation in a ZBLAN fiber pumped by a 2 μm MOPA system

Over 4000 Nm Bandwidth of Mid-Ir Supercontinuum Generation in Sub-Centimeter Segments of Highly Nonlinear Tellurite Pcfs

Ultrabroadband Scg with Quasi-Continuous Wave Nanosecond-Long Pump Pulses in Pcf