Abstract:Large-mode-area photonic crystal fiber is used to generate high power, high beam quality supercontinuum. Propagation and supercontinuum generation process of laser pulse in large-mode-area (LMA) photonic crystal fiber (PCF) is simulated by solving the general nonlinear Schrödinger equation (GNLSE) using the split-step Fourier method. Effects of the pump pulse parameters (peak power and chirp) and the length of photonic crystal fiber used on supercontinuum generation are particularly estimated. Nonlinear spectral broadening mechanism of laser pulse in large-mode-area photonic crystal fiber is discussed. The results show that the process of supercontinuum generation can be divided into three stages: initial broadening, dramatic broadening and saturation broadening. The spectrum width and efficiency can be achieved by the optimized length of LMA PCF to insure output of the generated supercontinuum at the dramatic broadening stage. The pump peak power and chirp have important impact on supercontinuum generation. When a small peak power pump is input, the spectrum broadens symmetrically. When the pump peak power increases, it brings little changes with the shorter wavelength component but broader of the longer wavelength component. The time-domain shape of the pulse exhibits concussion modulation as the effect of pulse breakup. When the pump chirp is positive, little influence is shown, except a shift of longer wavelength power by increasing the chirp. But the full width of the supercontinuum has little changes. While the pump chirp is negative and satisfy certain condition, the nonlinear is enhanced to facilitate the supercontinuum generation.

Combination of highly nonlinear fiber, an optical bandpass filter, and a Fabry-Perot filter to improve the signal-to-noise ratio of a supercontinuum continuous-wave optical source.

Supercontinuum generation based on nanofiber

Signal-to-noise ratio improvement of a supercontinuum continuous-wave optical source using a dispersion-imbalanced nonlinear optical loop mirror

Performance Improvement of a Supercontinuum Continuous-Wave Optical Source

Improving the performance of a multiwavelength continuous-wave optical source based on supercontinuum by suppressing degenerate four-wave mixing

Experimental and Numerical Study of Supercontinuum Generation in Photonic Crystal Fiber

Benefits of cascaded nonlinear dynamics in hybrid fibers for low-noise supercontinuum generation

All-fiber smooth supercontinuum generation in highly nonlinear dispersion-shifted fiber

High Power, Continuous-wave Supercontinuum Generation in Highly Nonlinear Fibers Pumped with High Order, Cascaded Raman Fiber Amplifiers

Performance Analysis for a Supercontinuum Continuous-Wave Optical Source for Dense Wavelength Division Multiplexed Transmission

All-Fiber Wideband Supercontinuum Generation in Short Hybrid Highly Nonlinear Fibers With a Femtosecond Erbium-Doped Fiber Laser

Experimental Study of Supercontinuum Generation in Step-Index Highly Nonlinear Fibres

Supercontinuum Generation in Photonic Crystal Fiber and Tapered Single-Mode Fiber

Compact Noise-Like Pulse Fiber Laser and Its Application for Supercontinuum Generation in Highly Nonlinear Fiber

A Proposal for Enhanced Parametric Amplification in Periodic Superstructure Fiber

Numerical investigation of a wideband supercontinuum source based on a large-mode-area photonic crystal fiber pumped at 1.3 μm

Supercontinuum Generation of Highly Nonlinear Fibers Pumped by 1.57 - Μ M Laser Soliton*

Supercontinuum generation and control from large-mode-area photonic crystal fiber

Optimization of supercontinuum generation in highly nonlinear fiber for DFG based mid-infrared frequency comb

Power-efficient Coherent Supercontinuum Generation by Two-Color Pulses Pumping in a Highly Nonlinear Fiber.

Combined Supercontinuum Source with >200 W Power Using a 3 × 1 Broadband Fiber Power Combiner.