Abstract:High average power, all-fiber integrated, broadband supercontinuum (SC) sources are demonstrated. Architecture for SC generation using amplified picosecond/nanosecond laser diode (LD) pulses followed by modulation instability (MI) induced pulse breakup is presented and used to demonstrate SC sources from the mid-IR to the visible wavelengths. In addition to the simplicity in implementation, this architecture allows scaling up of the SC average power by increasing the pulse repetition rate and the corresponding pump power, while keeping the peak power, and, hence, the spectral extent approximately constant. Using this process, we demonstrate >10W in a mid-IR SC extending from ∼0.8 to 4μm, >5W in a near IR SC extending from ∼0.8 to 2.8μm, and >0.7W in a visible SC extending from ∼0.45 to 1.2μm. SC modulation capability is also demonstrated in a mid-IR SC laser with ∼3.9W in an SC extending from ∼0.8 to 4.3μm. The entire system and SC output in this case is modulated by a 500Hz square wave at 50% duty cycle without any external chopping or modulation. We also explore the use of thulium doped fiber amplifier (TDFA) stages for mid-IR SC generation. In addition to the higher pump to signal conversion efficiency demonstrated in TDFAs compared to erbium/ytterbium doped fiber amplifier (EYFA), the shifting of the SC pump from ∼1.5 to ∼2μm is pursued with an attempt to generate a longer extending SC into the mid-IR. We demonstrate ∼2.5 times higher optical conversion efficiency from pump to SC generation in wavelengths beyond 3.8μm in the TDFA versus the EYFA based SC systems. The TDFA SC spectrum extends from ∼1.9 to 4.5μm with ∼2.6W at 50% modulation with a 250 Hz square wave. A variety of applications in defense, health care and metrology are also demonstrated using the SC laser systems presented in this paper.

Compact and efficient high-power mid-infrared supercontinuum fiber laser source based on a noise-like pulse and germania fiber

Supercontinuum generation based on nanofiber

All-fiber mid-infrared supercontinuum generation pumped by ultra-low repetition rate noise-like pulse mode-locked fiber laser

2 Mu M Femtosecond Fiber Laser Source And Its Application For Mid-Ir Supercontinuum Generation

165?MHz highly stable femtosecond Er:ZBLAN fiber laser operating at 2.8?μm

Ultraflat, Monolithic, Highly Stable Supercontinuum Source Based on Fluorotellurite Fiber

All-fiber ultra-flat supercontinuum source covering 1.85–3.57 μm based on germania-core fiber

Ultra-flat and high-efficient mid-infrared supercontinuum generation in indium fluoride fiber

Numerical Investigation on High Power Mid-Infrared Supercontinuum Fiber Lasers Pumped at 3 Μm.

High-Power Flat Supercontinuum Generation by Using UHNA7 Fiber With Spectrum of 1.77-3.31 μm

NIR to MIR Ultra-Broadband Supercontinuum Laser Source Based on All-Silica Fibers.

Modulation instability initiated high power all-fiber supercontinuum lasers and their applications

Kilowatt-Level Supercontinuum Generation in Random Raman Fiber Laser Oscillator With Full-Open Cavity

An ultra-flat, low-noise and linearly polarized fiber supercontinuum source covering 670 nm-1390 nm

Ultra-flat NIR-to-MIR Supercontinuum Source with All-Silica Fibers Based on Rectangular NLP Pumping

All-fiber flat 1.93.5 m supercontinuum source based on germaniacore fiber

Numerical Insights into noise amplification of high-energy mid-infrared supercontinuum generation in normal dispersion multimode fibers

Half Mj Supercontinuum Generation in A Telecommunication Multimode Fiber by A Q-Switched Tm, Ho:Yvo4 Laser

Towards High-Power Densely Step-Tunable Mid-Infrared Fiber Source From 4.27 to 4.43 μm in CO_2-Filled Anti-Resonant Hollow-Core Silica Fibers

Mid-infrared ultrashort pulses generated from a hybrid mode-locked Er:ZBLAN fiber laser

On-Chip Supercontinuum Generation Pumped by Short Wavelength Fiber Lasers