Abstract:Sandwich panel manufacturing (A) Without preheat (B) With preheat. An improved approach consisting of a combination of fiber placement and fused filament fabrication is introduced for the additive manufacture (AM) of structural grade sandwich beams. Here, sandwich beams are additively manufactured using in‐situ deposition and consolidation of continuous fiber unidirectional facings made from a commingled yarn system of e‐glass fiber (~50% vol.) and amorphous PET, and a hexagonal honeycomb core structure made from PETG. Both facings and the sandwich core are manufactured on a single machine, in one sequence (skin‐core‐skin), employing the benefit of matrix compatibility to create autohesion at the interfaces. Flexural and transverse shear rigidity are determined experimentally and compared with analytical predictions and show correlation to within 3%. Flexural strength and core shear strength are also measured. Post‐mortem examinations show that core fracture and core facing debond were the dominant failure mode in flexure. Single cantilever beam tests were performed to evaluate core facing debond toughness. Subsequently, surface preheat using infrared heaters was utilized to increase autohesion between core and facing. The results show debond toughness was increased 4 times using infrared heating. This research effort presents a manufacturing approach that has the potential for the AM of stiff, well bonded, structural grade sandwich beams, in an integrated sequence, employing in‐situ consolidation to the facings, without the need for the use of intermediate adhesives for skin‐to‐core bonding. Highlights An improved additive manufacturing technique for making sandwich panels is developed. Sandwich panel facings have fiber volume fractions of approximately 50%. Surface preheat improves core‐to‐facing debond toughness by a factor of 4. Top and bottom facings are consolidated during manufacture leading to better properties. Experimental results are compared to analytical predictions and show good correlation.

Additive manufacturing of ITER first wall panel parts by two approaches: Selective laser melting and electron beam melting

Effect of the Iter Fw Manufacturing Process on the Microstructure and Properties of A Cucrzr Alloy

China’s Technological Achievements on ITER Enhanced Heat Flux First Wall in the Pre-Pa Qualification

Study on the Microstructure and Properties Evolution of CuCrZr/316LN-IG Explosion Bonding for ITER First Wall Components

Progress of High Heat Flux Component Manufacture and Heat Load Experiments in China

Thermal fatigue failure behavior on Be/Cu joint of ITER first wall after enhanced heat flux test

Vacuum Hot-Pressed Beryllium and Tic Dispersion Strengthened Tungsten Alloy Developments for Iter and Future Fusion Reactors

Manufacturing and testing of ITER FW CuCrZr/316L(N)-IG explosive Bi-metallic plates

Microstructure and Mechanical Properties of 304L Steel Fabricated by Arc Additive Manufacturing

Progress in Developing ITER and DEMO First Wall Technologies at SWIP

Additive manufacturing of 316L stainless steel by electron beam melting for nuclear fusion applications

Additive Manufacturing of W/RAFM Hypervapotron Plasma-Facing Components and the Steady State Thermal Fatigue Behavior

Development and manufacturing of Beryllium-armoring ITER enhanced heat flux FW towards series production in China

Thermal-hydraulic and structural analyses of an additive manufactured panel mock-up for Wendelstein7-X

Additive manufacturing of sandwich panels with continuous fiber reinforced high modulus composite facings

Progress on design and R&D of ITER FW/blanket

Finite element analysis on the first wall electron beam welding of test blanket module

Additive manufacturing and characterization of titanium wall used in nuclear application

Research on High Layer Thickness Fabricated of 316L by Selective Laser Melting

Effect of interface-layer process parameters on forming quality of 316L/CuSn10 bimetals fabricated via laser powder bed fusion

Metal Fabrication by Additive Manufacturing Using Laser and Electron Beam Melting Technologies