Abstract:Numerical simulations of the cutting process play a key role in manufacturing and cost optimization. Inherent in finite element analysis (FEA) simulations is the correct description of material behavior during machining. For this purpose, various material models are used to describe the behavior of the material in the range of high deformation, high temperature values, and high strain rates. Very often the Johnson–Cook (JC) material model is used for this purpose; however, the correct determination of the material constants of this model is a key aspect. Therefore, this paper presents a procedure for determining the material constants of the JC model using an analytical method based on normalized tensile and compression testing of the material for different strain rates over a wide temperature range. After determining the material constants, the authors conducted numerical simulations of the orthogonal turning of Ti6Al4V titanium alloy using the obtained constants. Validation of the obtained results with those obtained in experimental studies was also carried out. The outcomes demonstrated that the difference between FEM simulation and experimental tests did not exceed 0.02 mm (14%) in the case of chip thickness,. Much smaller differences were obtained for the temperature in the cutting zone, where the maximum difference was about 45 °C (4%). Comparing the components of the cutting force, we found that, in the case of the main cutting force, in most cases, the differences did not exceed 70 N (8%). After the verification of the obtained results, it was also found that the determined material constants of the Johnson–Cook model can be successfully used in FEM modeling of the cutting process of Ti6Al4V titanium alloy for the adopted range of values of technological parameters.

Modification of strain rate strengthening coefficient for Johnson-Cook constitutive model of Ti6Al4V alloy

Research on Johnson–Cook Constitutive Model of γ-TiAl Alloy with Improved Parameters

Subroutine Embedding and Finite Element Simulation of the Improved Constitutive Equation for Ti6Al4V during High-Speed Machining

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Parametric Analysis and Improvement of the Johnson-Cook Model for a TC4 Titanium Alloy

Stress-Strain Curves and Modified Material Constitutive Model for Ti-6Al-4V over the Wide Ranges of Strain Rate and Temperature

Constitutive Model and Cutting Simulation of Titanium Alloy Ti6Al4V after Heat Treatment

A Modified Johnson–Cook Constitutive Model and Its Application to High Speed Machining of 7050-T7451 Aluminum Alloy

Modification of the Johnson-Cook relationship for AZ31 magnesium alloy at high strain rates

Inverse determination of improved constitutive equation for cutting titanium alloy Ti-6Al-4V based on finite element analysis

Two Methods for the Constitutive Modeling of TiB2/7050 Al Composites

Finite element simulations of Ti6Al4V titanium alloy machining to assess material model parameters of the Johnson-Cook constitutive equation

Dynamic Mechanical Properties and Modified Material Constitutive Model for Hot Forged Ti2AlNb over Wide Ranges of Temperature and Strain Rate

Johnson-cook constitutive equation for titanium alloy TC11

Correction of strain rate parameters of Johnson-Cook constitutive model for Ti-based metallic glass composites

A Modified Johnson-Cook Constitutive Equation to Predict Hot Deformation Behavior of Ti-6Al-4V Alloy

Determination and Verification of the Johnson–Cook Constitutive Model Parameters in the Precision Machining of Ti6Al4V Alloy

Research on Parameter Identification of Johnson–Cook Constitutive Model for TC17 Titanium Alloy Cutting Simulation

A modified Johnson-Cook model considering strain softening of A356 alloy

Study on constitutive relationship of 6061 aluminum alloy based on Johnson-Cook model

0610 A Comparative Study on Gao-Zhang and Johnson-Cook Constitutive Models