Abstract:The accuracy of a machining model depends on the capability of this model to describe the physical phenomena associated to the real machining system. This includes the material constitutive model and the approach used to describe the field flow of the material in cutting. In this paper, a model of high speed machining (HSM) of Ti6Al4V titanium alloy is developed. This cutting model includes the proposed constitutive model considering the influence of strain hardening, strain-rate, temperature, and state of stress (e.g., stress triaxiality and Lode parameter) in the material plasticity and damage. Finite Element Method (FEM) using Coupled EulerianLagrangian (CEL) approach is used to simulate the cutting model. A sensitivity analysis of the influence of the mesh topography on the chip geometry and cutting force is performed resulting in the determination of the optimal element size and element orientation. Simulation results obtained using the CEL approach are compared with those obtained using the Lagrangian one. Moreover, simulated cutting force and chip geometry obtained using the proposed constitutive model are compared with those obtained using the Johnson-Cook (J-C) model, and experimental data. Both chip geometry and cutting force predicted by the proposed constitutive model is closer to the experimental one than the J-C constitutive model. The CEL approach combined with the proposed constitutive model can simulate material side flow, which results in a larger width of chip compared to the width of cut, and in the formation of lateral burr on the workpiece. It also permits simulating the cyclic variation of the plastic strain and topography of the machined surface along the cutting direction, observed experimentally.

Constitutive Model of Physical Simulation in High Speed Cutting for Al6061-T6

Constitutive Model of Aviation Aluminum-Alloy Material in Metal Machining

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Dynamic tests and constitutive model for 7075-T6 aluminum alloy

A Modified Johnson–Cook Constitutive Model and Its Application to High Speed Machining of 7050-T7451 Aluminum Alloy

An improved material constitutive model for simulation of high-speed cutting of 6061-T6 aluminum alloy with high accuracy

Stress-Strain Curves and Modified Material Constitutive Model for Ti-6Al-4V over the Wide Ranges of Strain Rate and Temperature

Constitutive Model and Cutting Simulation of Titanium Alloy Ti6Al4V after Heat Treatment

Optimization of Milling Aluminum Alloy 6061-T6 using Modified Johnson-Cook Model

Subroutine Embedding and Finite Element Simulation of the Improved Constitutive Equation for Ti6Al4V during High-Speed Machining

0610 A Comparative Study on Gao-Zhang and Johnson-Cook Constitutive Models

Dynamic Mechanical Properties and Modified Material Constitutive Model for Hot Forged Ti2AlNb over Wide Ranges of Temperature and Strain Rate

MPM Simulations of High-Speed Machining of Ti6Al4V Titanium Alloy Considering Dynamic Recrystallization Phenomenon and Thermal Conductivity

On the Development of Material Constitutive Model for 45crnimova Ultra-High-Strength Steel

Experimental and Physical-Based Constitutive Model Study of Fcc Metal over Wide Temperature and Strain Rate Ranges

Simulation of Mechanical Response in Machining of Ti-6Al-4V Based on Finite Element Model and Visco-Plastic Self-Consistent Model

Machining Simulation of Ti6Al4V Using Coupled Eulerian-Lagrangian Approach and a Constitutive Model Considering the State of Stress

Research and Revise on Constitutive Equation of 7050-T7451 Aluminum Alloy in High Strain Rate and High Temperature Condition

Study on constitutive relationship of 6061 aluminum alloy based on Johnson-Cook model

Dynamic Mechanical Behavior of 6061 Al Alloy at Elevated Temperatures and Different Strain Rates