Abstract:Numerical simulations of the cutting process play a key role in manufacturing and cost optimization. Inherent in finite element analysis (FEA) simulations is the correct description of material behavior during machining. For this purpose, various material models are used to describe the behavior of the material in the range of high deformation, high temperature values, and high strain rates. Very often the Johnson–Cook (JC) material model is used for this purpose; however, the correct determination of the material constants of this model is a key aspect. Therefore, this paper presents a procedure for determining the material constants of the JC model using an analytical method based on normalized tensile and compression testing of the material for different strain rates over a wide temperature range. After determining the material constants, the authors conducted numerical simulations of the orthogonal turning of Ti6Al4V titanium alloy using the obtained constants. Validation of the obtained results with those obtained in experimental studies was also carried out. The outcomes demonstrated that the difference between FEM simulation and experimental tests did not exceed 0.02 mm (14%) in the case of chip thickness,. Much smaller differences were obtained for the temperature in the cutting zone, where the maximum difference was about 45 °C (4%). Comparing the components of the cutting force, we found that, in the case of the main cutting force, in most cases, the differences did not exceed 70 N (8%). After the verification of the obtained results, it was also found that the determined material constants of the Johnson–Cook model can be successfully used in FEM modeling of the cutting process of Ti6Al4V titanium alloy for the adopted range of values of technological parameters.

Numerical modeling and experimental assessment of dynamic behavior of aluminum alloy 7075-T6 in machining process

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

Numerical Simulation Study on Milling Force for Aerospace Aluminum Alloy

Constitutive Model of Aviation Aluminum-Alloy Material in Metal Machining

Simulation of 3d Chip Shaping of Aluminum Alloy 7075 in Milling Processes

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

A Modified Johnson–Cook Constitutive Model and Its Application to High Speed Machining of 7050-T7451 Aluminum Alloy

Material Behavior Modeling in Machining Simulation of 7075-T651 Aluminum Alloy

Optimization of Milling Aluminum Alloy 6061-T6 using Modified Johnson-Cook Model

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Finite Element Modeling for Orthogonal Machining of AA2024-T351 Alloy with an Advanced Fracture Criterion

Numerical Simulation and Experimental Study on the Drilling Process of 7075-t6 Aerospace Aluminum Alloy

Study on the Orthogonal Cutting Process of Al7050T7451 with Uncoated and Coated Tools

Constitutive Model of Physical Simulation in High Speed Cutting for Al6061-T6

Computer aided simulation and experimental investigation of the machinability of Al 6065 T6 during milling operation

Determination and Verification of the Johnson–Cook Constitutive Model Parameters in the Precision Machining of Ti6Al4V Alloy

Finite element simulations of Ti6Al4V titanium alloy machining to assess material model parameters of the Johnson-Cook constitutive equation

Study of dynamic mechanical behavior of 1060-H112 aluminum alloy: Experimental and numerical simulation

Parametric study of aluminum bar shearing using Johnson-Cook material modeling

Construction of a predictive model for residual stresses in micro-milling of 7075 aluminum alloy