Constitutive Model of Aviation Aluminum-Alloy Material in Metal Machining

YANG Yong,Ke Ying-lin,DONG Hui-yue

DOI: https://doi.org/10.3321/j.issn:1004-0609.2005.06.006

2005-01-01

Abstract:High temperature, high strain and high strain-rate of metal material in machining were not easy to get with a general measure method, which made it quite difficult to establish the dynamic constitutive model. To solve this problem, a combined modeling method based on “single factor” flow stress formula calculating and FEM simulation was proposed. The flow stress was repeated by calculated using the “single factor” flow stress formula, the metal machining process was simulated interatively with new flow stress. When simulating value was in good consistent with experimental result, the “three-high” data and flow stress data were obtained. By analyzing these data, it indicates that strain-rate can enhance the flow stress, while temperature will lower flow stress, and after remained in a steady state, each stress—strain curve will be parallel to the strain coordinate axis. Zerilli-Armstrong experience model was selected correspondingly. With the non-liner regression analysis, a dynamic constitutive model of aviation aluminum-alloy material during milling process was established. At last, the constitutive model is proved to be reasonable through test verification.