Abstract:The original Johnson-Cook model's poor prediction of W90 alloy stress at high strain rate and high and low temperatures restricts research and utilization of this alloy. This study used a Split Hopkinson Pressure Bar (SHPB) device to conduct dynamic compression tests on W90 alloy over a temperature range of [-90°C,700°C] and analyze its mechanical behavior. We examined the material's different plastic phase characteristics at high and low temperatures and conducted microstructure research on impact test specimens. Then, we analyzed the stress-strain data from SHPB experiments and quasi-static compression tests on the classical Johnson-Cook model. The original Johnson-Cook model was calibrated using the stress-strain data from SHPB and quasi-static compression tests, and the modified Johnson-Cook model was established and verified. The results show that: low temperature significantly strengthens the material's stress, while increasing temperature thermal softening reduces stress; increasing strain rate increases the strain generated by the workpiece, causing faster strain hardening and thermal softening effects, resulting in higher and more stable stress; low temperature makes thicker grain boundaries, increasing plastic stress, and increasing strain rate also increases plastic stress, as well as making the material's grain boundaries thicker. The increase of strain rate makes the grain more dense, which will also show up in the increase of stress on the macroscopic level; the modified Johnson-Cook model in this paper has high agreement with experimental data, with a mean value of MAPE of only 1.85 %,which is 90.20 % lower than the traditional model, and the average value of the RMSE is 85.56 % lower than the traditional model. The modified model significantly outperforms the traditional model in predicting stress and better describes stress changes in W90 at different temperatures.

0610 A Comparative Study on Gao-Zhang and Johnson-Cook Constitutive Models

On the Constitutive Models for Ultra-High Strain Rate Deformation of Metals

Constitutive Modelling of Plasticity of Fcc Metals under Extremely High Strain Rates

Comparative Study on Several Constitutive Models of GCr15 Steel at High Strain Rates

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Modification of the Johnson-Cook relationship for AZ31 magnesium alloy at high strain rates

Dynamic plasticity of AZ31 magnesium alloy: Experimental investigation and constitutive modeling

A Modified Johnson–Cook Constitutive Model and Its Application to High Speed Machining of 7050-T7451 Aluminum Alloy

A Constitutive Model for Dynamic Plasticity of FCC Metals

Thermomechanical Response of Commercially Pure Titanium under Large Plastic Deformation at High Strain Rates

Research on dynamic deformation behavior and constitutive relationship of hot forming high strength steel

Modified Johnson-Cook Constitutive Model for Dynamic Compressive Behaviors of C250 Maraging Steel at Different Temperatures

Study on constitutive relationship of 6061 aluminum alloy based on Johnson-Cook model

A modified parallel-sided shear zone model for determining material constitutive law

Dynamic constitutive relationship of CuCrZr alloy based on Johnson-Cook model

Constitutive Model of Physical Simulation in High Speed Cutting for Al6061-T6

Mechanical properties and JC constitutive modification of tungsten alloys under high strain rates and high/low temperatures

A new constitutive model for HCP metals

A constitutive description of tensile behavior for brass over a wide range of strain rates

Study on Dynamic Mechanical Performance and Fracture Behaviors of High Strength Steel

Physical Based Constitutive Model for the Prediction of Plastic Deformation of Fe‐Cr‐Ni Stainless Steel Under High Strain Rate