Abstract:The original Johnson-Cook model's poor prediction of W90 alloy stress at high strain rate and high and low temperatures restricts research and utilization of this alloy. This study used a Split Hopkinson Pressure Bar (SHPB) device to conduct dynamic compression tests on W90 alloy over a temperature range of [-90°C,700°C] and analyze its mechanical behavior. We examined the material's different plastic phase characteristics at high and low temperatures and conducted microstructure research on impact test specimens. Then, we analyzed the stress-strain data from SHPB experiments and quasi-static compression tests on the classical Johnson-Cook model. The original Johnson-Cook model was calibrated using the stress-strain data from SHPB and quasi-static compression tests, and the modified Johnson-Cook model was established and verified. The results show that: low temperature significantly strengthens the material's stress, while increasing temperature thermal softening reduces stress; increasing strain rate increases the strain generated by the workpiece, causing faster strain hardening and thermal softening effects, resulting in higher and more stable stress; low temperature makes thicker grain boundaries, increasing plastic stress, and increasing strain rate also increases plastic stress, as well as making the material's grain boundaries thicker. The increase of strain rate makes the grain more dense, which will also show up in the increase of stress on the macroscopic level; the modified Johnson-Cook model in this paper has high agreement with experimental data, with a mean value of MAPE of only 1.85 %,which is 90.20 % lower than the traditional model, and the average value of the RMSE is 85.56 % lower than the traditional model. The modified model significantly outperforms the traditional model in predicting stress and better describes stress changes in W90 at different temperatures.

A constitutive description of tensile behavior for brass over a wide range of strain rates

A Constitutive Model for Metals at High Strain Rates Accurately Determined by the Tensile Impact Recovery Experimental Technique

0610 A Comparative Study on Gao-Zhang and Johnson-Cook Constitutive Models

Study on constitutive relationship of 6061 aluminum alloy based on Johnson-Cook model

Constitutive Modelling of Plasticity of Fcc Metals under Extremely High Strain Rates

A Modified Johnson-Cook Model for 10%cr Steel at Elevated Temperatures and a Wide Range of Strain Rates

A Modified Johnson–Cook Constitutive Model for Characterizing the Hardening Behavior of Typical Magnesium Alloys under Tension at Different Strain Rates: Experiment and Simulation

A CONSTITUTIVE MODEL AND DATA FOR METALS SUBJECTED TO LARGE STRAINS, HIGH STRAIN RATES AND HIGH TEMPERATURES

Rate-Dependent Constitutive Models Of S690 High-Strength Structural Steel

Dynamic tensile behavior and rate-dependent constitutive model of 304 + Q235 bimetallic steel

A Constitutive Model for Dynamic Plasticity of FCC Metals

Mechanical properties and JC constitutive modification of tungsten alloys under high strain rates and high/low temperatures

Modified Johnson-Cook Constitutive Model for Dynamic Compressive Behaviors of C250 Maraging Steel at Different Temperatures

Modification of the Johnson-Cook relationship for AZ31 magnesium alloy at high strain rates

Strain-Rate Effect and Constitutive Models for Q550 High-Strength Structural Steel

High Strain Rate Behaviour of Stainless-Clad Bimetallic Steel

Identification of Dynamic Constitutive Parameters of a High-Strength Steel and Numerical Simulation

On the Constitutive Models for Ultra-High Strain Rate Deformation of Metals

Dynamic tensile behavior of S690 high-strength structural steel at intermediate strain rates

Constitutive modelling of the high strain rate behaviour of interstitial-free steel

Dynamic Mechanical Behavior and Constitutive Model of Stainless Steel