Abstract:A feasibility study on the compensation of 3D mispositioning errors of the probe occurring in the characterization of a long antenna, via a non-redundant (NR) near to far-field (NTFF) transformation with helicoidal scan, is conducted in this article. Such types of errors can result from imperfections in the rail driving the linear motion of the probe and from an imprecise synchronization of the linear and rotational movements of the probe and the antenna when drawing the scan helix. To correct them, an approach, which proceeds through two steps, is proposed. The former step uses a technique called cylindo rical wave (CW) correction for compensating the phase of the near-field (NF) samples, which, owing to the rail imperfections, result in not being acquired over the measurement cylinder surface. The latter exploits an iterative scheme to restore the samples at the sampling points required by the adopted NR representation along the scan helix from those obtained by applying the CW correction technique and impaired by 2D mispositioning errors. The so compensated NF samples are then effectively recovered via a 2D optimal sampling interpolation (OSI) scheme to accurately obtain the input data required to carry out the standard cylindrical NTFF transformation. The OSI representation is determined here by assuming a long antenna under test as enclosed in a prolate ellipsoid or cylinder ending into two hemispheres (cigar) in order to make, depending on the particular geometry of the considered antenna, the representation effectively non-redundant. The reported numerical simulation results show the capability of the proposed approach to compensate even severe 3D mispositioning errors, thus enabling its usage in a real measurement scenario.

Uncertainties Introduced by the Probe in Millimeter-Wave Planar Near-Field Measurements

Analytical Calculation of the Measuring Error of an Electromagnetic Velocity Probe Caused by a Side Channel Wall

Accurate and efficient planar near-field measurements: a new perspective from electromagnetic information theory.

An Efficient Probe Calibration Based Near-Field to Near-Field Transformation for EMI Diagnosis

Radiation behaviour of mm‐wave on‐wafer probes in H‐band and the influence on antenna measurements

Probe Design and Source Reconstruction for Near-Field Scanning and Modeling

Investigation of Multilayer Print Circuit Board Probe with Temperature Compensation for Ultra-Wideband Near-Field Measurement

A Miniature Multi-Component Probe for Near-Field Scanning

Probe-Fed Millimeter-Wave and Subterahertz Antenna Measurements: Challenges and solutions

Rigorous characterization of EMC antennas

Uncertainty propagation from probe spacing to Fourier 3-probe straightness measurement

A Wideband and High Sensitivity Probe Design for Near-Field Scanning

Influence of the PCB Manufacturing Process on the Measurement Error of Planar Relative Permittivity Sensors Up To 100 GHz

Review of Near-Field EMI Measurement

Design of Microstrip Line used for Probe Calibration up to 40 GHz

Phaseless Probe-Corrected Spherical Near-Field Antenna Measurements Using Two Scan Spheres

An Efficient Procedure to Compensate for the Errors Due to the Probe Mispositioning in a Cylindrical Near-Field Facility

Three-Dimensional Probe Mispositioning Errors Compensation: A Feasibility Study in the Non-Redundant Helicoidal Near to Far-Field Transformation Case

An Ultrawideband Asymmetric Calibration Method for a Simultaneously Electromagnetic Near-Field Probing System

On the uncertainty in numerical modeling of wireless communication devices operating at frequencies of 900 MHz, 1800 MHz, and 28 GHz

A Novel Four-Port Symmetric Probe Calibration Method for On-Wafer S-Parameter Measurement